SLVSHZ5 November 2026 TPS544628
ADVANCE INFORMATION
CLEAR_FAULTS is shown in Figure 7-3 and described in Table 7-6.
Return to the Summary Table.
Write Transaction: Send Byte
Read Transaction:N/A
Data Format: Data-less
NVM Back-up: No
Updates: On-the-fly CLEAR_FAULTS is a command used to clear any fault bits that have been set. This command clears all bits in all status registers. CLEAR_FAULTS is a write-only command with no data.The CLEAR_FAULTS command does not cause a unit that has latched off for a fault condition to restart. If the fault is still present when the bit is cleared, the fault bit is immediately set again and the host is notified by the usual means
| 7 | 6 | 5 | 4 | 3 | 2 | 1 | 0 |
| CLEAR_FAULTS | |||||||
| W-0h | |||||||
| Bit | Field | Type | Reset | Description |
|---|---|---|---|---|
| 7-0 | CLEAR_FAULTS | W | 0h | N/A |