JAJS842D May   1999  – February 2024 LM7171

PRODUCTION DATA  

  1.   1
  2. 1特長
  3. 2アプリケーション
  4. 3概要
  5. 4Pin Configuration and Functions
  6. 5Specifications
    1. 5.1 Absolute Maximum Ratings
    2. 5.2 ESD Ratings
    3. 5.3 Recommended Operating Conditions
    4. 5.4 Thermal Information
    5. 5.5 Electrical Characteristics: ±15V
    6. 5.6 Electrical Characteristics: ±5V
    7. 5.7 Typical Characteristics: LM7171A
    8. 5.8 Typical Characteristics: LM7171B
  7. 6Application and Implementation
    1. 6.1 Application Information
      1. 6.1.1 Circuit Operation
      2. 6.1.2 Slew Rate Characteristic
        1. 6.1.2.1 Slew-Rate Limitation
      3. 6.1.3 Compensation for Input Capacitance
    2. 6.2 Typical Applications
    3. 6.3 Power Supply Recommendations
      1. 6.3.1 Power-Supply Bypassing
      2. 6.3.2 Termination
      3. 6.3.3 Driving Capacitive Loads
      4. 6.3.4 Power Dissipation
    4. 6.4 Layout
      1. 6.4.1 Layout Guidelines
        1. 6.4.1.1 Printed Circuit Board and High-Speed Op Amps
        2. 6.4.1.2 Using Probes
        3. 6.4.1.3 Component Selection and Feedback Resistor
  8. 7Device and Documentation Support
    1. 7.1 ドキュメントの更新通知を受け取る方法
    2. 7.2 サポート・リソース
    3. 7.3 Trademarks
    4. 7.4 静電気放電に関する注意事項
    5. 7.5 用語集
  9. 8Revision History
  10. 9Mechanical, Packaging, and Orderable Information

パッケージ・オプション

メカニカル・データ（パッケージ｜ピン）
サーマルパッド・メカニカル・データ
発注情報

6.1.2.1 Slew-Rate Limitation

If the amplifier input signal amplitude is too large and the frequency too high, the amplifier is slew-rate limited. This limiting can cause ringing in the time domain and peaking in the frequency domain at the output of the amplifier.

For the AV = +2 curves, slight peaking occurs. This peaking at high frequency (> 100MHz) is due to a large input signal at a high enough frequency that exceeds the amplifier slew rate. The peaking in the frequency response does not limit the pulse response in the time domain, and the LM7171 is stable with a noise gain of ≥ +2.