SLAU789A November   2023  – November 2023

 

  1.   1
  2.   TSW1418EVM High-Speed Data Capture Card
  3.   Trademarks
  4. 1Introduction
    1. 1.1 REACH Compliance
  5. 2Functionality
    1. 2.1 ADC EVM Data Capture
  6. 3Hardware
    1. 3.1 Power Connections
    2. 3.2 Switches, Push-Buttons, Jumpers, and LEDs
      1. 3.2.1 Switches and Push-Buttons
      2. 3.2.2 Jumpers
      3. 3.2.3 LEDs
        1. 3.2.3.1 Power LED
        2. 3.2.3.2 Status LEDs
    3. 3.3 Connectors
      1. 3.3.1 SMA Connectors
      2. 3.3.2 FPGA Mezzanine Card (FMC) Connector
      3. 3.3.3 JTAG Connector
      4. 3.3.4 USB I/O Connection
  7. 4Software
    1. 4.1 Installation Instructions
    2. 4.2 USB Interface and Drivers
    3. 4.3 Downloading Firmware
  8. 5Revision History

3.2.3.1 Power LED

One LED on the TSW1418EVM is used to indicate the presence of power on the board. The description of this LED can be found in Table 3-3.

Table 3-3 Power and Configuration LED Descriptions
Component Description
D2 If this is on, then that indicates the presence of 5 V on the board.