SLAU913 august   2023 AFE539A4

 

  1.   1
  2.   Description
  3.   Get Started
  4.   Features
  5.   Applications
  6.   6
  7. 1Evaluation Module Overview
    1. 1.1 Introduction
    2. 1.2 Kit Contents
    3. 1.3 Specification
    4. 1.4 Device Information
  8. 2Hardware
    1. 2.1 Hardware Description
      1. 2.1.1 Theory of Operation
        1. 2.1.1.1 Signal Definitions
    2. 2.2 Hardware Setup
      1. 2.2.1 Electrostatic Discharge Caution
      2. 2.2.2 Power Configurations and Jumper Settings
      3. 2.2.3 Connecting the Hardware
  9. 3Software
    1. 3.1 Software Setup
      1. 3.1.1 Operating Systems
      2. 3.1.2 Software Installation
    2. 3.2 Software Description
      1. 3.2.1 Starting the Software
      2. 3.2.2 Software Features
        1. 3.2.2.1 High Level Configuration Page
        2. 3.2.2.2 Low Level Configuration Page
  10. 4Hardware Design Files
    1. 4.1 Schematic
    2. 4.2 PCB Layout
    3. 4.3 Bill of Materials
  11. 5Additional Information
    1.     Trademarks
  12. 6Related Documentation from Texas Instruments

Specification

The evaluation board default set up is configured for TEC control. TEC control is normally used for localized and precise temperature control which is a requirement for applications such as laser biasing or in-vitro diagnostics (IVD). The hardware on AFE539A4EVM is set up for such control. AFE539A4EVM is used to control the TEC through a DC/DC driver. The output of the device (pin OUT1 on the EVM) needs to be connected to the feedback pin of a buck-boost converter through a resister ladder.

The device software is not preconfigured, so registers need to be configured by using the GUI.