DLPU107A May 2022 – October 2025
2.4 Connecting EVM to the DLPC230-Q1 Control Program
- Start the DLPC230-Q1 Control Program Lite.
- On the connection page, set the DLPC230-Q1 Host to SPI and
select the Cheetah from the drop-down menu (see Figure 2-6). Note, the Cheetah must be connected to a computer with USB cable for it to
show up in the drop-down menu.
Figure 2-6 Connecting to the
DLPC230-Q1 Using the DLPC230-Q1 Automotive Control Program - Select Connection Settings to confirm
the SPI configuration shown in Figure 2-7 matches the controller PCB switch settings described in Table 1-3. Specifically, SPI mode and CRC/Checksum can vary based on switch settings.
When configuration is complete, press OK.
Figure 2-7 DLPC230-Q1 Automotive
Control Program Communication Settings - Click the Connect button. The green circle next to the Connect button then lights up to indicate that connection was successful to the Cheetah Adapter.