SBAU294A July   2020  – January 2023

 

  1.   Abstract
  2.   Trademarks
  3. 1Introduction
  4. 2 Equipment
    1. 2.1 Evaluation Board Feature Identification Summary
    2. 2.2 Required Equipment
  5. 3Setup Procedure
    1. 3.1 Install High-Speed Data Converter (HSDC) Pro Software
    2. 3.2 Install the Configuration GUI Software
    3. 3.3 Connect the ADC EVM and TSW1400EVM
    4. 3.4 Connect the Power Supply and Mini-USB Connections
    5. 3.5 Connect Signal Generators to ADC354xEVM
    6. 3.6 Configure HSDC Pro and Capture Data
  6. 4Device Configuration
    1. 4.1 Low Level Control
    2. 4.2 Current Monitoring
  7. 5Troubleshooting
  8. 6References
    1. 6.1 Analog Input Configuration
  9. 7Revision History

3.3 Connect the ADC EVM and TSW1400EVM

Connect the ADC354xEVM FMC connector to J1 of the FPGA Interposer Card.

Connect J2 of the FPGA Interposer Card to J1 of the TSW1400EVM.

GUID-20200716-CA0I-SCJH-G3KF-Z8W6DLS7LNXV-low.png Figure 3-1 ADC354xEVM Full Setup