SLLA661A April   2025  – June 2026 MCF8315A , MCF8315C , MCF8315C-Q1 , MCF8315D , MCF8316A , MCF8316C-Q1 , MCF8316D , MCF8329A , MCF8329A-Q1

 

  1.   1
  2.   Abstract
  3.   Trademarks
  4. 1Introduction
  5. 2System Requirements
  6. 3 MOTORSTUDIO GUI Installation
  7. 4Prerequisites to Run the Motor with MOTORSTUDIO
  8. 5Getting Started with MOTORSTUDIO
    1. 5.1 Home
    2. 5.2 SmartTune
    3. 5.3 Optimization Wizard
    4. 5.4 Motor Parameter Extraction Tool (MPET)
    5. 5.5 Closed Loop Tuning
    6. 5.6 Advanced Tuning
    7. 5.7 Register Map
      1. 5.7.1 Register read
    8. 5.8 Control Utilities
      1. 5.8.1 Control
        1. 5.8.1.1 EEPROM READ/WRITE
      2. 5.8.2 Faults
      3. 5.8.3 Charts
      4. 5.8.4 Logs
    9. 5.9 Other Utilities
      1. 5.9.1 Scripting Tool
      2. 5.9.2 Compare Tuning File Tool
  9. 6Spinning the motor
    1. 6.1 Connecting MCF83xx to the GUI
    2. 6.2 SmartTune Execution
    3. 6.3 Improving Current and Speed Regulation
    4. 6.4 Testing for Successful Startup Into Closed Loop
  10. 7Summary
  11. 8References
  12. 9Revision History

5.6 Advanced Tuning

Advanced Tuning Figure 5-6 Advanced Tuning

This page provides users with the option to navigate different settings organized by motor operating stages, similar to the optimization wizard. Users can select the motor operating stages in the diagram at the top, and the GUI will open the corresponding configuration tab for access.

Reference Profile Figure 5-7 Reference Profile

The Advanced Tuning page also provides users with the option to configure the reference profile graphically.

  1. Users can choose one of the reference profile options (Linear mode, Staircase mode, and Forward/Reverse mode) from the "Ref Profile Config" drop-down menu.
  2. The reference profile graph can be plotted with different units (Percentage, RPM, and Hz). The motor's number of poles needs to be selected for reference profile plotting with RPM.
  3. "Load Default Profile" will load the default graph. Users can modify the profile coordinates using the drag-and-drop method.
  4. Users can also alter the profile by selecting one of the coordinates and adjusting the value using the Command Speed (%) and Output Speed (%) sliders.
  5. Users can adjust the speed-duty coordinates by selecting the desired coordinate and moving and dropping it to the desired location.