SLUUD65A April   2025  – December 2025

 

  1.   1
  2.   Description
  3.   Get Started
  4.   Features
  5.   Applications
  6.   6
  7. 1Evaluation Module Overview
    1. 1.1 Introduction
    2. 1.2 Kit Contents
    3. 1.3 Specifications
    4. 1.4 Device Information
  8. 2Hardware
    1. 2.1 Header Information
    2. 2.2 Jumper Information
    3. 2.3 Equipment
    4. 2.4 Hardware Setup
  9. 3Software
    1. 3.1 Software Setup
    2. 3.2 Test Procedure
      1. 3.2.1 Initial Power Up
      2. 3.2.2 I2C Register Communication Verification
      3. 3.2.3 Charger Mode Verification
      4. 3.2.4 Boost Mode Verification
      5. 3.2.5 Helpful Tips
  10. 4Hardware Design Files
    1. 4.1 Schematic
    2. 4.2 PCB Layout
      1. 4.2.1 PCB Layout Guidelines
    3. 4.3 Bill of Materials (BOM)
  11. 5Additional Information
    1.     Trademarks
  12. 6Revision History

3.2.2 I2C Register Communication Verification

Use the following steps for communication verification :

  1. In the EVM software, click the BQ25630EVM button
    • Verify that the GUI reads BQ25630EVM in the top right corner.
      Note:

      If the device reads BQ25630EVM verify Section 2.4 and Section 3.2.1 steps have been followed.

  2. In the Field View (see Figure 3-3), make the following changes as necessary:
    • Set BQ25630EVM
    • Set BQ25630EVM
    • Set BQ25630EVM
    • Set BQ25630EVM
    • Set BQ25630EVM
    • Set BQ25630EVM
    • Set BQ25630EVM
    • Check BQ25630EVM
    • Uncheck BQ25630EVM