SLVAF85 September   2026 TPS2596 , TPS25961

 

  1.   1
  2.   Abstract
  3.   Trademarks
  4. 1Introduction
  5. 2Conventional RC Circuit-Based Design
  6. 3Proposed Design with eFuse
  7. 4Comparison Summary and Conclusion
  8. 5References

Comparison Summary and Conclusion

Table 4-1 Capacitor Size Comparison: Conventional RC vs eFuse-Based Design
Conventional RC-based Design eFuse-Based Design
Current Limit in Latching Phase (mA) Capacitor Installed (uF) Capacitor Size (mm2) Capacitor Installed (uF) Capacitor Size (mm2)
120 3300 400 1500 225
150 2200 313 1000 200
180 2200 313 470 125

Table 4-1 compares the capacitor requirements of the conventional RC-based and eFuse-based designs for different latching current limits. The eFuse-based design has significantly reduced the required capacitor size and the reduction in capacitor size can offset the additional eFuse cost, reducing the overall design cost.

The eFuse supplements the hold-up capacitor by utilizing the available supply power during the pulsed load, reducing the required capacitor size for a given backup time. With dynamic current limiting, the eFuse operates at a lower current limit during latching and a higher current limit during normal operation. This allows greater utilization of the available supply power and further reduces the hold-up capacitor requirement. The TPS25961 also provides overvoltage protection, overload and short-circuit protection, improving overall system protection.