SLVS052J April   1988  – September 2026 TL594

PRODUCTION DATA  

  1.   1
  2. 1 Features
  3. 2 Applications
  4. 3 Description
  5. 4 Pin Configuration and Functions
  6. 5 Specifications
    1. 5.1 Absolute Maximum Ratings
    2. 5.2 ESD Ratings
    3. 5.3 Recommended Operating Conditions
    4. 5.4 Thermal Information
    5. 5.5 Electrical Characteristics
    6. 5.6 Switching Characteristics
    7. 5.7 Typical Characteristics
  7. 6 Parameter Measurement Information
  8. 7 Detailed Description
    1. 7.1 Overview
    2. 7.2 Functional Block Diagram
    3. 7.3 Feature Description
      1. 7.3.1 5V Reference Regulator
      2. 7.3.2 Undervoltage Lockout
      3. 7.3.3 Oscillator
      4. 7.3.4 Dead-Time Control
      5. 7.3.5 Comparator
      6. 7.3.6 Pulse-Width Modulation (PWM)
      7. 7.3.7 Error Amplifiers
      8. 7.3.8 Output-Control Input
      9. 7.3.9 Output Transistors
    4. 7.4 Device Functional Modes
  9. 8 Application and Implementation
    1. 8.1 Application Information
    2. 8.2 Typical Application
      1. 8.2.1 Design Requirements
      2. 8.2.2 Detailed Design Procedure
        1. 8.2.2.1 Input Power Source
        2. 8.2.2.2 Control Circuits
          1. 8.2.2.2.1 Oscillator
          2. 8.2.2.2.2 Error Amplifier
          3. 8.2.2.2.3 Current-Limiting Amplifier
          4. 8.2.2.2.4 Soft Start
          5. 8.2.2.2.5 Setting the Dead Time
        3. 8.2.2.3 Inductor Calculations
        4. 8.2.2.4 Output Capacitance Calculations
        5. 8.2.2.5 Transistor Power-Switch Calculations
      3. 8.2.3 Application Curve
    3. 8.3 Power Supply Recommendations
    4. 8.4 Layout
      1. 8.4.1 Layout Guidelines
        1. 8.4.1.1 Feedback Traces
        2. 8.4.1.2 Input or Output Capacitors
        3. 8.4.1.3 Compensation Components
        4. 8.4.1.4 Traces and Ground Planes
      2. 8.4.2 Layout Example
  10. 9 Device and Documentation Support
    1. 9.1 Documentation Support
      1. 9.1.1 Related Documentation
    2. 9.2 Receiving Notification of Documentation Updates
    3. 9.3 Support Resources
    4. 9.4 Trademarks
    5. 9.5 Electrostatic Discharge Caution
    6. 9.6 Glossary
  11. 10Revision History
  12. 11Mechanical, Packaging, and Orderable Information

Feedback Traces

Try to run the feedback trace as far from the inductor and noisy power traces as possible. The feedback trace must be as direct as possible and wider to decrease impedance. These two sometimes involve a trade-off, but keeping it away from inductor EMI and other noise sources is the more critical of the two. Run the feedback trace on the side of the PCB opposite of the inductor, ideally with a ground plane separating the two.