SLVSHH4A July   2024  – April 2025 TPS546E25

PRODUCTION DATA  

1.   1
2. 1 Features
3. 2 Applications
4. 3 Description
5. 4 Pin Configuration and Functions
6. 5 Specifications
   1. 5.1 Absolute Maximum Ratings
   2. 5.2 ESD Ratings
   3. 5.3 Recommended Operating Conditions
   4. 5.4 Thermal Information
   5. 5.5 Electrical Characteristics
   6. 5.6 Typical Characteristics
7. 6 Detailed Description
   1. 6.1 Overview
   2. 6.2 Functional Block Diagram
   3. 6.3 Feature Description
      1. 6.3.1  D-CAP4 Control
         1. 6.3.1.1 Loop Compensation
      2. 6.3.2  Internal VCC LDO and Using an External Bias on the VCC Pin and VDRV Pin
      3. 6.3.3  Input Undervoltage Lockout (UVLO)
         1. 6.3.3.1 Fixed VCC_OK UVLO
         2. 6.3.3.2 Fixed VDRV UVLO
         3. 6.3.3.3 Programmable PVIN UVLO
         4. 6.3.3.4 Control (CNTL) Enable
      4. 6.3.4  Differential Remote Sense and Internal, External Feedback Divider
      5. 6.3.5  Set the Output Voltage and VORST#
      6. 6.3.6  Start-Up and Shutdown
      7. 6.3.7  Dynamic Voltage Slew Rate
      8. 6.3.8  Set Switching Frequency
      9. 6.3.9  Switching Node (SW)
      10. 6.3.10 Overcurrent Limit and Low-side Current Sense
      11. 6.3.11 Negative Overcurrent Limit
      12. 6.3.12 Zero-Crossing Detection
      13. 6.3.13 Input Overvoltage Protection
      14. 6.3.14 Output Overvoltage and Undervoltage Protection
      15. 6.3.15 Overtemperature Protection
      16. 6.3.16 Telemetry
   4. 6.4 Device Functional Modes
      1. 6.4.1 Forced Continuous-Conduction Mode
      2. 6.4.2 DCM Light Load Operation
      3. 6.4.3 Powering the Device From a 12V Bus
      4. 6.4.4 Powering the Device From a Split-rail Configuration
      5. 6.4.5 Pin-Strapping
         1. 6.4.5.1 Programming MSEL1
         2. 6.4.5.2 Programming PMB_ADDR
         3. 6.4.5.3 Programming MSEL2
         4. 6.4.5.4 Programming VSEL\FB
   5. 6.5 Programming
      1. 6.5.1 Supported PMBus® Commands
8. 7 Register Maps
   1. 7.1  Conventions for Documenting Block Commands
   2. 7.2  (01h) OPERATION
   3. 7.3  (02h) ON_OFF_CONFIG
   4. 7.4  (03h) CLEAR_FAULTS
   5. 7.5  (04h) PHASE
   6. 7.6  (09h) P2_PLUS_WRITE
   7. 7.7  (0Ah) P2_PLUS_READ
   8. 7.8  (0Eh) PASSKEY
   9. 7.9  (10h) WRITE_PROTECT
   10. 7.10 (15h) STORE_USER_ALL
   11. 7.11 (16h) RESTORE_USER_ALL
   12. 7.12 (19h) CAPABILITY
   13. 7.13 (1Bh) SMBALERT_MASK
   14. 7.14 (20h) VOUT_MODE
   15. 7.15 (21h) VOUT_COMMAND
   16. 7.16 (22h) VOUT_TRIM
   17. 7.17 (24h) VOUT_MAX
   18. 7.18 (25h) VOUT_MARGIN_HIGH
   19. 7.19 (26h) VOUT_MARGIN_LOW
   20. 7.20 (27h) VOUT_TRANSITION_RATE
   21. 7.21 (29h) VOUT_SCALE_LOOP
   22. 7.22 (2Ah) VOUT_SCALE_MONITOR
   23. 7.23 (2Bh) VOUT_MIN
   24. 7.24 (33h) FREQUENCY_SWITCH
   25. 7.25 (35h) VIN_ON
   26. 7.26 (36h) VIN_OFF
   27. 7.27 (39h) IOUT_CAL_OFFSET
   28. 7.28 (40h) VOUT_OV_FAULT_LIMIT
   29. 7.29 (41h) VOUT_OV_FAULT_RESPONSE
   30. 7.30 (42h) VOUT_OV_WARN_LIMIT
   31. 7.31 (43h) VOUT_UV_WARN_LIMIT
   32. 7.32 (44h) VOUT_UV_FAULT_LIMIT
   33. 7.33 (45h) VOUT_UV_FAULT_RESPONSE
   34. 7.34 (46h) IOUT_OC_FAULT_LIMIT
   35. 7.35 (48h) IOUT_OC_LV_FAULT_LIMIT
   36. 7.36 (49h) IOUT_OC_LV_FAULT_RESPONSE
   37. 7.37 (4Ah) IOUT_OC_WARN_LIMIT
   38. 7.38 (4Fh) OT_FAULT_LIMIT
   39. 7.39 (50h) OT_FAULT_RESPONSE
   40. 7.40 (51h) OT_WARN_LIMIT
   41. 7.41 (55h) VIN_OV_FAULT_LIMIT
   42. 7.42 (60h) TON_DELAY
   43. 7.43 (61h) TON_RISE
   44. 7.44 (64h) TOFF_DELAY
   45. 7.45 (65h) TOFF_FALL
   46. 7.46 (78h) STATUS_BYTE
   47. 7.47 (79h) STATUS_WORD
   48. 7.48 (7Ah) STATUS_VOUT
   49. 7.49 (7Bh) STATUS_IOUT
   50. 7.50 (7Ch) STATUS_INPUT
   51. 7.51 (7Dh) STATUS_TEMPERATURE
   52. 7.52 (7Eh) STATUS_CML
   53. 7.53 (7Fh) STATUS_OTHER
   54. 7.54 (80h) STATUS_MFR_SPECIFIC
   55. 7.55 (88h) READ_VIN
   56. 7.56 (8Bh) READ_VOUT
   57. 7.57 (8Ch) READ_IOUT
   58. 7.58 (8Dh) READ_TEMPERATURE_1
   59. 7.59 (98h) PMBUS_REVISION
   60. 7.60 (99h) MFR_ID
   61. 7.61 (9Ah) MFR_MODEL
   62. 7.62 (9Bh) MFR_REVISION
   63. 7.63 (ADh) IC_DEVICE_ID
   64. 7.64 (AEh) IC_DEVICE_REV
   65. 7.65 (D1h) SYS_CFG_USER1
   66. 7.66 (D3h) PMBUS_ADDR
   67. 7.67 (D4h) COMP
   68. 7.68 (D5h) VBOOT_OFFSET_1
   69. 7.69 (D6h) STACK_CONFIG
   70. 7.70 (D8h) PIN_DETECT_OVERRIDE
   71. 7.71 (D9h) NVM_CHECKSUM
   72. 7.72 (DAh) READ_TELEMETRY
   73. 7.73 (DBh) STATUS_ALL
   74. 7.74 (DDh) EXT_WRITE_PROTECTION
   75. 7.75 (DEh) IMON_CAL
   76. 7.76 (FCh) FUSION_ID0
   77. 7.77 (FDh) FUSION_ID1
9. 8 Application and Implementation
   1. 8.1 Application Information
   2. 8.2 Typical Application
      1. 8.2.1 Application
      2. 8.2.2 Design Requirements
      3. 8.2.3 Detailed Design Procedure
         1. 8.2.3.1 Input Capacitor Selection
         2. 8.2.3.2 Inductor Selection
         3. 8.2.3.3 Output Capacitor Selection
         4. 8.2.3.4 Compensation Selection
         5. 8.2.3.5 VCC and VRDV Bypass Capacitors
         6. 8.2.3.6 BOOT Capacitor Selection
         7. 8.2.3.7 VOSNS and GOSNS Capacitor Selection
         8. 8.2.3.8 PMBus® Address Resistor Selection
      4. 8.2.4 Application Curves
   3. 8.3 Power Supply Recommendations
   4. 8.4 Layout
      1. 8.4.1 Layout Guidelines
      2. 8.4.2 Layout Example
         1. 8.4.2.1 Thermal Performance on TPS546E25EVM
10. 9 Device and Documentation Support
    1. 9.1 Documentation Support
       1. 9.1.1 Related Documentation
    2. 9.2 Receiving Notification of Documentation Updates
    3. 9.3 Support Resources
    4. 9.4 Trademarks
    5. 9.5 Electrostatic Discharge Caution
    6. 9.6 Glossary
11. 10Revision History
12. 11Mechanical, Packaging, and Orderable Information