SLVSJC3 September   2025 BQ79826Z-Q1

ADVANCE INFORMATION  

  1.   1
  2. 1Features
  3. 2Applications
  4. 3Description
  5. 4Pin Configuration and Functions
  6. 5Device and Documentation Support
    1. 5.1 Documentation Support
    2. 5.2 Receiving Notification of Documentation Updates
    3. 5.3 Support Resources
    4. 5.4 Trademarks
    5. 5.5 Electrostatic Discharge Caution
    6. 5.6 Glossary
  7. 6Mechanical, Packaging, and Orderable Information
    1. 6.1 Package Option Addendum
    2. 6.2 Tape and Reel Information
    3. 6.3 Mechanical Data

1 Features

  • 26 Channels
    • 26S – 0 to 5.5V range for cell, -2V to 2V range for busbar
    • 143V Abs Max Rating, 9V minimum
    • Busbar support on every channel, except first channel.
    • Stackable up to 128 devices
  • Voltage Accuracy
    • <1.7 mV accuracy, -40 to 125C, Cell: 0V to 5.5V
    • Dedicated ADC per channel. Synchronized redundant measurement.
  • Passive Cell Balancing with integrated FETs up to 300mA odd/even balancing with programmable PWM control
  • Smart EIS Engine
    • Integrated Electrochemical Impedance Spectroscopy measurement engine
    • Impedance Accuracy: 1% (with 1A excitation and 200uΩ impedance)
    • Measurement frequency: 0.01Hz to 3.5kHz
    • < 5us I/V synchronization from device to device
    • Support for global and local excitation
  • Sensor & GPIOs
    • 20 GPIO: Temp Sensor (NTC/PTC), voltage measurement, Interrupt
    • SPI / I2C Interface
    • Temperature Threshold (Active / Sleep)
    • Pressure Threshold / Peak Detector (Active / Sleep)
    • On-chip memory for one-time custom programming
  • Diagnostics & Protection
    • Monitoring
      • Low Power Monitoring Mode (<20uA power consumption)
      • Cell Over-voltage, Under-voltage (OVUV)
      • Cell Over-temperature, Under-temperature (OTUT)
      • 2x die temperature monitors
      • Supply (BAT)
      • Open Wire Detection
    • Reverse Wake Up based on selectable faults
    • Redundancy Paths
      • Cell Voltage
      • GPIO/NTC Voltage
      • Limp Home Mode
    • Diagnostics
      • Automatic diagnostics during cell balancing in active mode
    • Functional Safety Compliant
      • Developed under ISO26262
      • System and hardware capability up to ASIL-D
  • Upgraded Daisy Chain Interface
    • 2Mbps bus speed, Up to 4Mbps with dual SPI
    • <+/-5us device to device synchronization
    • Closed Loop BCI: 200mA, Open Loop BCI: 300mA
    • Isolation: Transformer or capacitor-only
    • FDTI Time: <100ms for 800V packs or 250 cells
    • Support for stack, ring, multidrop, and split-ring
    • Device-to-device automatic communications balancing
  • Power
    • Integrated DC-DC Converter
    • Shutdown: <10uA
    • Sleep Mode with monitoring: As low as 20uA
    • Active Mode: <5mA
  • Package
    • 100-pin QFP, 4mm pitch
    • PowerPad on bottom