SLVUCZ2 May   2024

 

  1.   1
  2.   Description
  3.   Get Started
  4.   Features
  5.   Applications
  6.   6
  7. 1Evaluation Module Overview
    1. 1.1 Introduction
    2. 1.2 Kit Contents
    3. 1.3 Specification
    4. 1.4 Device Information
  8. 2Hardware
    1. 2.1 Headers and Test Points Information
    2. 2.2 Connector Information
    3. 2.3 Indicator LEDs
    4. 2.4 Hardware Setup
  9. 3Software
    1. 3.1 Web GUI Access or Local GUI Installation
    2. 3.2 Connecting EVM to GUI
    3. 3.3 GUI Overview
    4. 3.4 DRV8000-Q1EVM
      1. 3.4.1 Register Map
  10. 4Hardware Design Files
    1. 4.1 Schematics
    2. 4.2 PCB Layout
    3. 4.3 Bill of Materials (BOM)
  11. 5Additional Information
    1. 5.1 Trademarks

2.2 Connector Information

DRV8000-Q1EVM, Connectors Figure 2-3 Connectors
Table 2-2 Connectors Description
Component LabelDescription
AInput power supply connector. Power cables can be directly connected to the screw terminals or clipped to the test points on either side of the connector.
BHigh-side driver output connectors
CHalf-bridge output connectors
DUSB connector
EGround strap can be used as ground for probes and other connectors.
FEC mirror output and ground. Ground located on the right side of terminal block.
GHeater output and ground. Ground located on the right side of terminal block.
HH-Bridge outputs. SH1 and SH2 are right side and left side of the terminal blocks respectively.