SLVUE53 October   2026

 

  1.   1
  2.   Description
  3.   Get Started
  4.   Features
  5.   Applications
  6.   6
  7. 1Evaluation Module Overview
    1. 1.1 Introduction
    2. 1.2 Kit Contents
    3. 1.3 Specification
    4. 1.4 Device Information
  8. 2Hardware
    1. 2.1 Power Requirements
    2. 2.2 Setup
    3. 2.3 Header Information
    4. 2.4 Jumper Information
    5. 2.5 Test Points
  9. 3Hardware Design Files
    1. 3.1 Schematics
    2. 3.2 PCB Layouts
    3. 3.3 Bill of Materials (BOM)
  10. 4Additional Information
    1. 4.1 Trademarks

2.5 Test Points

Table 2-3 describes each test point function.

Table 2-3 Test Points Information
Section Test Point Name Description
XTR100 TP1 LOOP+ Loop supply (LOOP+)
TP2 VIN Input signal
TP3 XTR_OUT XTR output
TP4 LOOP- Loop supply (LOOP-)
TP6 LDO_IN Input to LDO
TP7 VCC Supply voltage to XTR (Output from LDO)
TP8, TP9, TP10 GND GND for XTR100
XTR102 TP11 H_RX HART receive
TP12 VCC Supply voltage to XTR (Output from LDO)
TP13 LDO_IN Input to LDO
TP14 VREF Reference output
TP15 LOOP+ Loop supply (LOOP+)
TP16 H_TX HART transmit
TP17 XTR_OUT XTR output
TP18 LOOP- Loop supply (LOOP-)
TP19 VIN Input signal
TP20, TP21, TP22, TP23, TP24 GND_B GND for XTR102
XTR120 TP25 H_RX HART receive
TP26 H_TX HART transmit
TP27 LOOP+ Loop supply (LOOP+)
TP28 XTR_OUT XTR output
TP29 LOOP- Loop supply (LOOP-)
TP30 PWM_IN Input signal (PWM)
TP31 LDO_IN Input to LDO
TP32 VCC Supply voltage to XTR (Output from LDO)
TP33, TP34, TP35, TP36, TP37, TP38 GND_C GND for XTR120