SLVUE86 October   2026

 

  1.   1
  2.   Description
  3.   Features
  4.   Applications
  5.   5
  6. 1Evaluation Module Overview
    1. 1.1 Introduction
    2. 1.2 Kit Contents
    3. 1.3 Specification
    4. 1.4 Device Information
  7. 2Hardware
    1. 2.1 General Configurations
      1. 2.1.1 Physical Access
      2. 2.1.2 Test Equipment and Setup
        1. 2.1.2.1 Power Supplies
        2. 2.1.2.2 Meters
        3. 2.1.2.3 Oscilloscope
        4. 2.1.2.4 Loads
        5. 2.1.2.5 USB-to-GPIO Interface Adapter
  8. 3Implementation Results
    1. 3.1 Test Setup and Procedures
    2. 3.2 Test Results
      1. 3.2.1 Input Hot-Plug
      2. 3.2.2 Start-Up with Enable
        1. 3.2.2.1 Start-Up With Constant Output Voltage Slew-Rate
        2. 3.2.2.2 Start-Up With PLIM Hiccup Mode
      3. 3.2.3 Power-Up Into Short
        1. 3.2.3.1 Power-Up Into Short in Constant Output Voltage Slew-Rate-Based Start-Up
        2. 3.2.3.2 Power-Up Into Short in PLIM Hiccup Mode
      4. 3.2.4 Undervoltage and Overvoltage Lockout
      5. 3.2.5 Overcurrent Performance
      6. 3.2.6 Output Hot Short
  9. 4Hardware Design Files
    1. 4.1 Schematic
    2. 4.2 PCB Layouts
    3. 4.3 Bill of Materials (BOM)
  10. 5Additional Information
    1. 5.1 Trademarks

1.2 Kit Contents

Table 1-1 LMI800PSEVM: Kit Contents
ItemDescriptionQuantity
LMI800PSEVMEvaluation module for LMI800PS hot-swap controller1
Important: The USB-TO-GPIO2 adapter is not included in the kit and needs to be separately ordered at USB-TO-GPIO2 Evaluation board | TI.com.