This section describes how to set up the LP5811-10EVM properly. Items from the following list are required to begin evaluating the LP5811/LP5810:

• Computer
• LP5811-10EVM
• USB2ANY interface adapter

In the default jumper setting, the board can be evaluated by USB2ANY power directly and does not need an external power supply. Setup connection is demonstrated in Figure 2-1. The setup procedure is as follows:

1. Connect the USB2ANY with the LP5811-10EVM using the ribbon cable.
2. Make sure all jumpers are properly set under the appropriate operating conditions. See more details in Section 2.2.
3. Plug the USB cable into the USB port on the computer.

Figure 2-1 Hardware Connection