These 8-bit flip-flops feature 3-state outputs designed specifically for driving highly capacitive or relatively low-impedance loads. These devices are particularly suitable for implementing multiuser registers, I/O ports, bidirectional bus drivers, and working registers.
With the clock-enable (
)
input low, the eight D-type edge-triggered flip-flops enter data on
the low-to-high transitions of the clock (CLK) input. Taking high disables the clock buffer,
latching the outputs. These devices have noninverting data (D)
inputs. Taking the clear (
)
input low causes the eight Q outputs to go low independently of the
clock.
Multiuser buffered output-enable (
,
, and 
) inputs can be used to place the
eight outputs in either a normal logic state (high or low logic
level) or a high-impedance state. In the high-impedance state, the
outputs neither load nor drive the bus lines significantly. The
high-impedance state and increased drive provide the capability to
drive bus lines without interface or pullup components.
The output enables do not affect the internal operation of the flip-flops. Old data can be retained or new data can be entered while the outputs are in the high-impedance state.
The SN54AS825A is characterized for operation over the full military temperature range of -55°C to 125°C. The SN74AS825A is characterized for operation from 0°C to 70°C.
= H if any of
OE1\, OE2\, or OE3\ are high.
= L if all of
OE1\, OE2\, or OE3\ are low.
| Tipo | Título | Fecha | ||
|---|---|---|---|---|
| * | Data sheet | 8-Bit Bus-Interface Flip-Flops With 3-State Outputs datasheet (Rev. B) | 01 ago 1995 |
El contenido lo proporcionan “tal como está” TI y los colaboradores de la comunidad y no constituye especificaciones de TI. Consulte los términos de uso.
Si tiene preguntas sobre la calidad, el paquete o el pedido de productos de TI, consulte el soporte de TI.