首頁 數據轉換器 類比轉數位轉換器 (ADC) 精確 ADC
首頁
數據轉換器
類比轉數位轉換器 (ADC)
精確 ADC

ADS131M06-Q1

現行

車用、六通道、24 位元、32-kSPS 同時取樣 delta-sigma ADC

立即訂購
產品規格表

ADS131M06-Q1

現行
產品規格表 立即訂購

產品詳細資料

Resolution (Bits) 24 Sample rate (max) (ksps) 32 Number of input channels 6 Interface type SPI Architecture Delta-Sigma Input type Differential, Single-ended Multichannel configuration Simultaneous Sampling Rating Automotive TI functional safety category Functional Safety-Capable Reference mode External, Internal Input voltage range (max) (V) 3.6 Input voltage range (min) (V) -1.3 Features PGA, Small Size Operating temperature range (°C) -40 to 125 Power consumption (typ) (mW) 5 Analog supply voltage (min) (V) 2.7 Analog supply voltage (max) (V) 3.6 SNR (dB) 101 Digital supply (min) (V) 1.65 Digital supply (max) (V) 3.6
Resolution (Bits) 24 Sample rate (max) (ksps) 32 Number of input channels 6 Interface type SPI Architecture Delta-Sigma Input type Differential, Single-ended Multichannel configuration Simultaneous Sampling Rating Automotive TI functional safety category Functional Safety-Capable Reference mode External, Internal Input voltage range (max) (V) 3.6 Input voltage range (min) (V) -1.3 Features PGA, Small Size Operating temperature range (°C) -40 to 125 Power consumption (typ) (mW) 5 Analog supply voltage (min) (V) 2.7 Analog supply voltage (max) (V) 3.6 SNR (dB) 101 Digital supply (min) (V) 1.65 Digital supply (max) (V) 3.6
TQFP (PBS) 32 49 mm² (7 mm × 7 mm)
  • AEC-Q100 qualified for automotive applications:
    • Temperature grade 1: –40°C to +125°C, TA
  • Functional Safety-Capable
  • 6 simultaneously sampling differential inputs
  • Programmable data rate up to 32 kSPS
  • Programmable gain up to 128
  • Noise performance:
    • 102-dB dynamic range at gain = 1, 4 kSPS
    • 80-dB dynamic range at gain = 64, 4 kSPS
  • Total harmonic distortion: –100 dB
  • High-impedance inputs for direct sensor connection:
    • 330-kΩ input impedance for gains of 1, 2, and 4
    • ≥1-MΩ input impedance for gains of 8, 16, 32, 64, and 128
  • Programmable channel-to-channel phase delay calibration:
    • Resolution = 244 ns, fCLKIN = 8.192 MHz
  • Fast start-up: First data within 0.5 ms of supply ramp
  • Integrated negative charge pump allows input signals below ground
  • Crosstalk between channels: –120 dB
  • Low-drift internal voltage reference
  • Cyclic redundancy check (CRC) on communications and register map
  • Analog and digital supplies: 2.7 V to 3.6 V
  • Low-power consumption: 4.9 mW at 3-V AVDD and DVDD
  • Package: 32-pin TQFP
  • AEC-Q100 qualified for automotive applications:
    • Temperature grade 1: –40°C to +125°C, TA
  • Functional Safety-Capable
  • 6 simultaneously sampling differential inputs
  • Programmable data rate up to 32 kSPS
  • Programmable gain up to 128
  • Noise performance:
    • 102-dB dynamic range at gain = 1, 4 kSPS
    • 80-dB dynamic range at gain = 64, 4 kSPS
  • Total harmonic distortion: –100 dB
  • High-impedance inputs for direct sensor connection:
    • 330-kΩ input impedance for gains of 1, 2, and 4
    • ≥1-MΩ input impedance for gains of 8, 16, 32, 64, and 128
  • Programmable channel-to-channel phase delay calibration:
    • Resolution = 244 ns, fCLKIN = 8.192 MHz
  • Fast start-up: First data within 0.5 ms of supply ramp
  • Integrated negative charge pump allows input signals below ground
  • Crosstalk between channels: –120 dB
  • Low-drift internal voltage reference
  • Cyclic redundancy check (CRC) on communications and register map
  • Analog and digital supplies: 2.7 V to 3.6 V
  • Low-power consumption: 4.9 mW at 3-V AVDD and DVDD
  • Package: 32-pin TQFP

The ADS131M06-Q1 is a six-channel, simultaneously sampling, 24-bit, delta-sigma (ΔΣ), analog-to-digital converter (ADC) that offers wide dynamic range and low power, making the device designed for automotive battery management systems (BMS). The ADC inputs can be directly interfaced to shunt resistors for bidirectional battery-current measurements, to resistor-divider networks for high-voltage measurements, or to temperature sensors (such as thermistors or analog output temperature sensors).

The individual ADC channels can be independently configured depending on the sensor input. A low-noise, programmable gain amplifier (PGA) provides gains ranging from 1 to 128 to amplify low-level signals. Additionally, this device integrates channel-to-channel phase calibration and offset and gain calibration registers to help remove signal-chain errors.

A low-drift, 1.2-V reference is integrated into the device reducing printed circuit board (PCB) area. Optional cyclic redundancy checks (CRCs) on the data input, data output, and register map maintain communication integrity.

The complete analog front-end (AFE) is offered in a 32-pin TQFP package and is specified over the automotive temperature range of –40°C to +125°C.

The ADS131M06-Q1 is a six-channel, simultaneously sampling, 24-bit, delta-sigma (ΔΣ), analog-to-digital converter (ADC) that offers wide dynamic range and low power, making the device designed for automotive battery management systems (BMS). The ADC inputs can be directly interfaced to shunt resistors for bidirectional battery-current measurements, to resistor-divider networks for high-voltage measurements, or to temperature sensors (such as thermistors or analog output temperature sensors).

The individual ADC channels can be independently configured depending on the sensor input. A low-noise, programmable gain amplifier (PGA) provides gains ranging from 1 to 128 to amplify low-level signals. Additionally, this device integrates channel-to-channel phase calibration and offset and gain calibration registers to help remove signal-chain errors.

A low-drift, 1.2-V reference is integrated into the device reducing printed circuit board (PCB) area. Optional cyclic redundancy checks (CRCs) on the data input, data output, and register map maintain communication integrity.

The complete analog front-end (AFE) is offered in a 32-pin TQFP package and is specified over the automotive temperature range of –40°C to +125°C.
filter 尋找其它 精確 ADC
下載 觀看有字幕稿的影片 影片

您可能會感興趣的類似產品

open-in-new 比較替代產品
針腳對針腳的功能與所比較的裝置相同。
ADS131M08-Q1 現行 車用、八通道、24 位元、32-kSPS、同時取樣 delta-sigma ADC 8-channel version
功能相同，但針腳輸出與所比較的裝置不同。
ADS131M02-Q1 現行 車用二通道、24 位元、64-kSPS、同時取樣、delta-sigma ADC 2-channerl version
ADS131M04-Q1 現行 車用四通道、24 位元、64-kSPS 同時取樣 delta-sigma ADC 4-channel version
ADS131M03-Q1 現行 車用三通道、24 位元、64-kSPS、同時取樣、delta-sigma ADC 3-channel version

技術文件

找不到結果。請清除您的搜尋條件，然後再試一次。
檢視所有 5
重要文件 類型 標題 格式選項 下載最新的英文版本 日期
* 資料表 ADS131M06-Q1 Automotive, 6-Channel, 32-kSPS, Simultaneous-Sampling, 24-Bit, Delta-Sigma ADC datasheet PDF | HTML 2022/8/15
應用說明 A Simple, Java-Based CRC Calculator PDF | HTML 2026/3/4
應用說明 Digital Filter Types in Delta-Sigma ADCs (Rev. A) PDF | HTML 2023/3/29
功能安全資訊 ADS131M06-Q1 Functional Safety FIT Rate, FMD and Pin FMA PDF | HTML 2022/6/14
更多文件說明 Addressing BMS Battery Pack Current and Voltage Measurement Requirements 2022/5/5

設計與開發

如需其他條款或必要資源，請按一下下方的任何標題以檢視詳細頁面 (如有)。

開發板

ADS131M08EVM — 適用於八通道、24 位元、同步取樣和 delta-sigma ADC 的 ADS131M08 評估模組

ADS131M08 評估模組 (EVM) 是用於評估 ADS131M08 的平台，ADS131M08 是一款低功率、八通道、同步取樣、delta-sigma 類比數位轉換器 (ADC)。

ADS131M08EVM 套件包含 ADS131M08EVM 電路板和可啟用隨附電腦軟體的精密主機介面 (PHI) 控制器電路板。

使用指南: PDF
支援產品和硬體
有庫存
限制：
??asset.out-of-stock-ti_zh_TW??
無法提供
模擬型號

ADS131M06/08 IBIS Model (Rev. A)

SBAM435A.IBS (308 KB) - IBIS 模型
支援產品和硬體
計算工具

ADC-DESIGN-CALC — Online design calculator tool for TI Precision ADCs

ADC-DESIGN-CALC is an online resource with multiple ADC calculator tools (such as Digital Filter Response, Code-to-Voltage, CMR, CRC, etc.) for TI Precision ADCs.
支援產品和硬體
計算工具

ANALOG-ENGINEER-CALC — PC software analog engineer's calculator

類比工程師的計算機旨在加速類比電路設計工程師定期使用的許多重複計算。此基於 PC 的工具提供圖形介面，列出各種常見計算，從使用回饋電阻器設定運算放大器增益到選擇適當的電路設計元件以穩定類比數位轉換器 (ADC) 驅動緩衝電路。

除了作為獨立工具使用外，此計算機還與類比工程師口袋參考中描述的概念相得益彰。

支援產品和硬體
設計工具

ADC-DAC-TO-VREF-SELECT-DESIGN-TOOL — The ADC-TO-VREF-SELECT tool enables the pairing of TI ADCs, DACs, and series voltage references.

The ADC-TO-VREF-SELECT tool enables the pairing of TI analog-to-digital converters (ADCs) and series voltage references. Users can select an ADC device and the desired reference voltage, and the tool will list up to two voltage reference recommendations.
支援產品和硬體
封裝 針腳 CAD 符號、佔位空間與 3D 模型
TQFP (PBS) 32 Ultra Librarian
適用 TI 的評估品項標準條款與條件。

訂購與品質

建議產品可能具有與此 TI 產品相關的參數、評估模組或參考設計。

支援與培訓

內含 TI 工程師技術支援的 TI E2E™ 論壇

以英文檢視所有論壇主題

內容係由 TI 和社群貢獻者依「現狀」提供，且不構成 TI 規範。檢視使用條款。

若有關於品質、封裝或訂購 TI 產品的問題，請參閱 TI 支援。​​​​​​​​​​​​​​

影片