產品詳細資料

Local sensor accuracy (max) 2 Type Remote Operating temperature range (°C) -40 to 140 Supply voltage (min) (V) 3 Interface type I2C, SMBus Supply voltage (max) (V) 3.6 Features ALERT, One-shot conversion Supply current (max) (µA) 800 Temp resolution (max) (bps) 11 Remote channels (#) 4 Addresses 3 Rating Catalog
Local sensor accuracy (max) 2 Type Remote Operating temperature range (°C) -40 to 140 Supply voltage (min) (V) 3 Interface type I2C, SMBus Supply voltage (max) (V) 3.6 Features ALERT, One-shot conversion Supply current (max) (µA) 800 Temp resolution (max) (bps) 11 Remote channels (#) 4 Addresses 3 Rating Catalog
WSON (NHL) 14 16 mm² 4 x 4
  • Accurately Senses Die Temperature of 4 Remote ICs or Diode Junctions and Local Temperature
  • Local Temperature Accuracy ±2.0°C (Maximum)
  • Remote Diode Temperature Accuracy ±1.1°C (Maximum)
  • Supply Voltage: 3 V to 3.6 V
  • Average Supply Current (1-Hz Conversion Rate) 0.57 mA (Typical)
  • Programmable Digital Filters and Analog Front-End Filter
  • 0.125°C LSB Temperature Resolution
  • 0.03125°C LSB Remote Temperature Resolution With Digital Filter Enabled
  • Signed Format: +127.875°C/–128°C Remote Range
  • Unsigned Format: 0°C/255°C Remote Range
  • Remote Diode Fault Detection, Model Selection, and Offset Correction
  • Mask and Status Register Support
  • 3 Programmable TCRIT Outputs With Programmable Shared Hysteresis and Fault-Queue
  • Programmable Conversion Rate and Shutdown Mode One-Shot Conversion Control
  • SMBus 2.0 Compatible Interface, Supports TIMEOUT
  • Three-Level Address Pin
  • Accurately Senses Die Temperature of 4 Remote ICs or Diode Junctions and Local Temperature
  • Local Temperature Accuracy ±2.0°C (Maximum)
  • Remote Diode Temperature Accuracy ±1.1°C (Maximum)
  • Supply Voltage: 3 V to 3.6 V
  • Average Supply Current (1-Hz Conversion Rate) 0.57 mA (Typical)
  • Programmable Digital Filters and Analog Front-End Filter
  • 0.125°C LSB Temperature Resolution
  • 0.03125°C LSB Remote Temperature Resolution With Digital Filter Enabled
  • Signed Format: +127.875°C/–128°C Remote Range
  • Unsigned Format: 0°C/255°C Remote Range
  • Remote Diode Fault Detection, Model Selection, and Offset Correction
  • Mask and Status Register Support
  • 3 Programmable TCRIT Outputs With Programmable Shared Hysteresis and Fault-Queue
  • Programmable Conversion Rate and Shutdown Mode One-Shot Conversion Control
  • SMBus 2.0 Compatible Interface, Supports TIMEOUT
  • Three-Level Address Pin

The LM95214 device is an 11-bit digital temperature sensor with a 2-wire System Management Bus (SMBus) interface that can very accurately monitor the temperature of four remote diodes as well as its own temperature. The four remote diodes can be external devices such as microprocessors, graphics processors that target the ideality of a 2N3904 transistor or diode-connected 2N3904s.

The LM95214 reports temperature in two different formats for +127.875°C/–128°C range and 0°C/255°C range. The LM95214 TCRIT1, TCRIT2 and TCRIT3 outputs are triggered when any unmasked channel exceeds its corresponding programmable limit and can be used to shutdown the system, to turn on the system fans or as a microcontroller interrupt function. The current status of the TCRIT1, TCRIT2, and TCRIT3 pins can be read back from the status registers. Mask registers are available for further control of the TCRIT outputs.

Two LM95214 remote temperature channels have programmable digital filters while the other two remote channels use a fault-queue to minimize unwanted TCRIT events when temperature spikes are encountered.

For optimum flexibility and accuracy, each LM95214 channel includes registers for offset correction. A three-level address pin allows connection of up to 3 LM95214s to the same SMBus master. The LM95214 includes power saving functions such as: programmable conversion rate, shutdown mode, and disabling of unused channels.

The LM95214 device is an 11-bit digital temperature sensor with a 2-wire System Management Bus (SMBus) interface that can very accurately monitor the temperature of four remote diodes as well as its own temperature. The four remote diodes can be external devices such as microprocessors, graphics processors that target the ideality of a 2N3904 transistor or diode-connected 2N3904s.

The LM95214 reports temperature in two different formats for +127.875°C/–128°C range and 0°C/255°C range. The LM95214 TCRIT1, TCRIT2 and TCRIT3 outputs are triggered when any unmasked channel exceeds its corresponding programmable limit and can be used to shutdown the system, to turn on the system fans or as a microcontroller interrupt function. The current status of the TCRIT1, TCRIT2, and TCRIT3 pins can be read back from the status registers. Mask registers are available for further control of the TCRIT outputs.

Two LM95214 remote temperature channels have programmable digital filters while the other two remote channels use a fault-queue to minimize unwanted TCRIT events when temperature spikes are encountered.

For optimum flexibility and accuracy, each LM95214 channel includes registers for offset correction. A three-level address pin allows connection of up to 3 LM95214s to the same SMBus master. The LM95214 includes power saving functions such as: programmable conversion rate, shutdown mode, and disabling of unused channels.

下載 觀看有字幕稿的影片 影片

您可能會感興趣的類似產品

open-in-new 比較替代產品
引腳對引腳且具備與所比較裝置相同的功能
LM95234 現行 具 TruTherm™ 技術和 SMBus 介面的 ±2°C 雙遠端和本機溫度感測器 TruTherm technology BJT beta compensation.

技術文件

star =TI 所選的此產品重要文件
找不到結果。請清除您的搜尋條件,然後再試一次。
檢視所有 1
類型 標題 日期
* Data sheet LM95214 Quad Remote Diode and Local Temperature Sensor With SMBus Interface datasheet (Rev. B) PDF | HTML 2017年 8月 29日

設計與開發

如需其他條款或必要資源,請按一下下方的任何標題以檢視詳細頁面 (如有)。

支援軟體

SENSOREVAL Eval Board Software For Hardware Monitors And Digital Temperature Sensors

SensorEval
SensorEval software supports the latest TI temperature sensor and hardware monitor evaluation boards via USB interface. It also allows access to sensors mounted directly on motherboards that support Intel chip sets.

  • Download SensorEval Software and Manual
  • Windows XP support is offered for (...)
支援產品和硬體

支援產品和硬體

產品
數位溫度感測器
LM63 具風扇控制的 1 個遠端與本機溫度感測器 LM64 具風扇控制與 5 個 GPIO 的 1 個遠端與本機溫度感測器 LM71 具 SPI 介面的 ±1.5°C 溫度感測器 LM71-Q1 具 SPI 介面的汽車級、±1.5°C 溫度感測器 LM73 具 I2C/SMBus 介面的 ±1°C 溫度感測器 LM75A 2C 業界標準溫度感測器、I2C/SMBus 介面 LM86 具 SMBu 介面的 ±0.75°C 遠端和本機溫度感測器 LM89 具 SMBus 介面和 2 個匯流排分載位址的 ± 0.75 ° C 遠端和本機溫度感測器 LM90 具 SMBus 介面的遠端和本機溫度感測器 LM93 具硬體監控器和 16 個電源電壓監控器的 2 個遠端、1 個本機溫度感測器 LM95010 具 SensorPath 介面的 ±2°C 溫度感測器 LM95071 具 SPI 介面的 ±1°C 溫度感測器 LM95172-Q1 具 200°C 功能和 SPI 介面的汽車級 ±1°C 溫度感測器 LM95214 具 SMBus 介面的 ±2°C 四遠端和本機溫度感測器 LM95221 具 beta 補償和 SMBus、I2C 介面的 ±3°C 雙遠端和本機溫度感測器 LM95231 具 TruTherm™ 技術和 SMBus 介面的雙遠端和本機溫度感測器 LM95233 具 TruTherm™ 技術和 SMBus 介面的 ±2°C 雙遠端和本機溫度感測器 LM95234 具 TruTherm™ 技術和 SMBus 介面的 ±2°C 雙遠端和本機溫度感測器 LM95235 具 SMBus、beta 補償且適用 65/90nm 二極體的 ±0.75°C 遠端和本機溫度感測器 LM95235-Q1 具 TruTherm™ 技術和 SMBus 的汽車級 ±2°C 遠端和本機溫度感測器 LM95241 具 beta 補償和 SMBus、I2C 介面的 ±1.25°C 雙遠端和本機溫度感測器 LM95245 具 SMBus、beta 補償且適用 45nm 二極體的 ±0.75°C 遠端和本機溫度感測器 LM96000 具風扇控制和 6 個電源電壓監控器的硬體監控器 LM96080 具風扇速度和電源電壓監控器的 1 個本機溫度感測器 LM96163 具 beta 補償和風扇控制的 1 個遠端與本機溫度感測器 LM99 具 TruTherm™ 技術和 SMBus 介面的遠端和本機溫度感測器
精確 ADC
ADC128D818 具溫度感測器、內部/外部電壓參考和 I2C 介面的 12 位元 82SPS 8 通道 ΔΣ ADC
模擬型號

LM95214 IBIS Model

SNIM011.ZIP (20 KB) - IBIS Model
封裝 針腳 CAD 符號、佔位空間與 3D 模型
WSON (NHL) 14 Ultra Librarian

訂購與品質

內含資訊:
  • RoHS
  • REACH
  • 產品標記
  • 鉛塗層/球物料
  • MSL 等級/回焊峰值
  • MTBF/FIT 估算值
  • 材料內容
  • 認證摘要
  • 進行中持續性的可靠性監測
內含資訊:
  • 晶圓廠位置
  • 組裝地點

支援與培訓

內含 TI 工程師技術支援的 TI E2E™ 論壇

內容係由 TI 和社群貢獻者依「現狀」提供,且不構成 TI 規範。檢視使用條款

若有關於品質、封裝或訂購 TI 產品的問題,請參閱 TI 支援。​​​​​​​​​​​​​​

影片