Serial communications have been widely used in grid infrastructure equipments. But the limitation of transmission distance and bandwidth of serial communication leads to demand for a more flexible and high-speed method to meet modern smart grid network migration. Ethernet has been accepted as an efficient communications method across industries in the last decade. This design demonstrates bi-directional switching and transmission between serial ports and Ethernet ports, which can enable legacy equipment that has only serial communication in their power grid to communicate with modern, Ethernet-based equipment without any changes to the existing hardware or software.
• Reduced complexity , BOM cost and component count.
• 10/100 Ethernet MAC with Advanced IEEE 1588 PTP Hardware and both MII Interface and RMII Interface supported
• Provision to Connect to External Boards for Isolated Communication Interface and POE
• Onboard Non-isolated CAN and RS-485 PHY
• 50-Pin Connector for External Interface with MII/RMII Ethernet PHY
• 1024-KB Flash Memory and 256-KB Single-Cycle System SRAM
완조립 보드는 테스팅과 성능 검증을 위해서만 개발되었으며 판매를 위한 것이 아닙니다.
바로 사용 가능한 시스템 파일을 다운로드하여 설계 프로세스에 속도를 높여 보십시오.
설계 구성요소, 참조 지정자 및 제조업체/부품 번호의 전체 목록
TI 제품을 설계 및 잠재적 대안에 포함합니다.
| 유형 | 직함 | 최신 영어 버전 다운로드 | 날짜 | ||
|---|---|---|---|---|---|
| * | 설계 가이드 | 32-Bit ARM Cortex-M4F MCU-Based Small Form Factor Serial-to-Ethernet Converter | 2014. 5. 13 | ||
| 기술 문서 | Overcoming Ethernet connectivity challenges on the power grid | PDF | HTML | 2019. 6. 27 |