JAJSSB8A November   2023  – April 2024 TDP2004

PRODUCTION DATA  

  1.   1
  2. 1 特長
  3. 2 アプリケーション
  4. 3 概要
  5. 4 Pin Configuration and Functions
  6. 5 Specifications
    1. 5.1 Absolute Maximum Ratings
    2. 5.2 ESD Ratings
    3. 5.3 Recommended Operating Conditions
    4. 5.4 Thermal Information
    5. 5.5 DC Electrical Characteristics
    6. 5.6 High Speed Electrical Characteristics
    7. 5.7 SMBUS/I2C Timing Characteristics
    8. 5.8 Typical Characteristics
    9. 5.9 Typical Jitter Characteristics
  7. 6 Detailed Description
    1. 6.1 Overview
    2. 6.2 Functional Block Diagram
    3. 6.3 Feature Description
      1. 6.3.1 Linear Equalization
      2. 6.3.2 Flat-Gain
    4. 6.4 Device Functional Modes
      1. 6.4.1 Active Mode
      2. 6.4.2 Standby Mode
    5. 6.5 Programming
      1. 6.5.1 Pin mode
        1. 6.5.1.1 Five-Level Control Inputs
      2. 6.5.2 SMBUS/I2C Register Control Interface
        1. 6.5.2.1 Shared Registers
        2. 6.5.2.2 Channel Registers
      3. 6.5.3 SMBus/I 2 C Primary Mode Configuration (EEPROM Self Load)
  8. 7 Application and Implementation
    1. 7.1 Application Information
    2. 7.2 Typical Applications
      1. 7.2.1 DP 2.1 Mainlink Signal Conditioning
        1. 7.2.1.1 Design Requirements
        2. 7.2.1.2 Detailed Design Procedure
        3. 7.2.1.3 Application Curves
    3. 7.3 Power Supply Recommendations
    4. 7.4 Layout
      1. 7.4.1 Layout Guidelines
      2. 7.4.2 Layout Example
  9. 8 Device and Documentation Support
    1. 8.1 ドキュメントの更新通知を受け取る方法
    2. 8.2 サポート・リソース
    3. 8.3 Trademarks
    4. 8.4 静電気放電に関する注意事項
    5. 8.5 用語集
  10. 9 Revision History
  11. 10Mechanical, Packaging, and Orderable Information

パッケージ・オプション

デバイスごとのパッケージ図は、PDF版データシートをご参照ください。

メカニカル・データ（パッケージ｜ピン）
  • RNQ|40
サーマルパッド・メカニカル・データ
発注情報

5.3 Recommended Operating Conditions

over operating free-air temperature range (unless otherwise noted)
MIN NOM MAX UNIT
VCC Supply voltage, VCC to GND DC plus AC power must not exceed these limits 3.0 3.3 3.6 V
NVCC(1) Supply noise tolerance DC to <50Hz, sinusoidal 250 mVpp
50Hz to 500kHz, sinusoidal 100 mVpp
500kHz to 2.5MHz, sinusoidal 33 mVpp
Supply noise, >2.5MHz, sinusoidal 10 mVpp
TRampVCC VCC supply ramp time From 0V to 3.0V 0.150 100 ms
TA Operating ambient temperature TDP2004 0 70 °C
TDP2004I –40 85 °C
TJ Operating junction temperature TDP2004 105 °C
TDP2004I 125 °C
PWLVCMOS Minimum pulse width required for the device to detect a valid signal on LVCMOS inputs PD and READ_EN_N 200 μs
VCCSMBUS SMBus/I2C SDA and SCL open-drain termination voltage Supply voltage for open-drain pullup resistor 3.6 V
FSMBus SMBus/I2C clock (SCL) frequency SMBus secondary mode 10 400 kHz
VIDLAUNCH Source launch amplitude Differential signaling 1200 mVpp
DR Data rate 1 20 Gbps
(1) Sinusoidal noise is superimposed to supply voltage with negligeable impact to device function or critical performance shown in the Electrical Table. Steps must be taken to ensure the combined AC plus DC supply noise meets the specified VDD supply voltage limits.