SNLU226B February   2018  – April 2021 DS90UB960-Q1

 

  1. 1 Introduction
  2. 2 Features
  3. 3 Application Diagram
  4. 4 Major Components
  5. 5 Quick Start Guide
  6. 6 Board Connections
    1. 6.1 Power Supply
    2. 6.2 Power Over Coax Interface
    3. 6.3 MIPI CSI-2 Output Signals
    4. 6.4 FPD-Link III Signals
    5. 6.5 I2C Interface
    6. 6.6 Control Interface
  7. 7 Enable and Reset
  8. 8 ALP Software Setup
    1. 8.1  System Requirements
    2. 8.2  Download Contents
    3. 8.3  Installation of the ALP Software
    4. 8.4  Startup - Software Description
    5. 8.5  Information Tab
    6. 8.6  Registers Tab
    7. 8.7  Registers Tab - Address 0x00 Selected
    8. 8.8  Registers Tab - Address 0x00 Expanded
    9. 8.9  Scripting Tab
    10. 8.10 Sample ALP Python Script
      1. 8.10.1 Initialization
  9. 9 Troubleshooting ALP Software
    1. 9.1 ALP Loads the Incorrect Profile
    2. 9.2 ALP does not detect the EVM
  10. 10Typical Connection and Test Equipment
  11. 11Termination Device
  12. 12Typical Test Setup
  13. 13Equipment References
  14. 14Cable References
  15. 15Bill of Materials
  16. 16PCB Schematics
  17. 17Board Layout
  18. 18Revision History

4 Major Components

Figure 4-1 illustrates major DS90UB960-Q1EVM components.

  1. Quad Mini-Fakra connector for FPD-Link III interfaces. There is also a Quad Mini-Fakra to 4x Single Fakra coax cable assembly (not shown) for interfacing the EVM to up to four sensor modules
  2. Samtec QSH type connectors for interfacing the CSI-2 I/Os to downstream processors
  3. Switches for configuring DS90UB960-Q1 functional modes
  4. USB2ANY connector for interfacing the EVM to a PC
  5. Connectors for accessing DS90UB960-Q1 I2C Ports
  6. Connectors for accessing DS90UB960-Q1 GPIOs
  7. Barrel jack type connector for powering the DS90UB960-Q1EVM from a single 12V/1A supply
  8. Connectors for selecting PoC voltage source

GUID-B9C6D383-6573-4523-866D-4807860D893A-low.gifFigure 4-1 Interfacing to the EVM

To demonstrate the functionality, the following components are also required (not included):

  1. At least one DS90UB953-Q1EVM or a camera module (Up to four may be used)
  2. USB to Mini USB cable OR I2C host controller that support clock stretching (Such As USB2ANY)
  3. Power supply capable of supporting 12V, 1A load
  4. Optional: MIPI-CSI-2 output analyzer or Host Processor