計算工具
TPS40200
- Input Voltage Range 4.5 V to 52 V
- Output Voltage (700 mV to 90% VIN)
- 200-mA Internal P-channel FET Driver
- Voltage Feed-Forward Compensation
- Undervoltage Lockout
- Programmable Fixed-Frequency (between 35 kHz
and 500 kHz) Operation - Programmable Short-Circuit Protection
- Hiccup Overcurrent Fault Recovery
- Programmable Closed-Loop Soft-Start
- 700 mV 1% Reference Voltage
- External Synchronization
- Small 8-Pin SOIC (D) and VSON (DRB) Packages
The TPS40200 is a flexible, non-synchronous controller with a built-in 200-mA driver for P-channel FETs. The circuit operates with inputs up to 52 V with a power-saving feature that turns off driver current once the external FET has been fully turned on. This feature extends the flexibility of the device, allowing it to operate with an input voltage up to 52 V without dissipating excessive power. The circuit operates with voltage-mode feedback and has feed-forward input voltage compensation that responds instantly to input voltage change. The integral 700-mV reference is trimmed to 2%, providing the means to accurately control low voltages. The TPS40200 is available in an 8-pin SOIC and an 8-pin VSON package and supports many of the features of more complex controllers. Clock frequency, soft-start, and overcurrent limits are each easily programmed by a single, external component. The part has undervoltage lockout, and can be easily synchronized to other controllers or a system clock to satisfy sequencing and/or noise-reduction requirements.
技術文件
找不到結果。請清除您的搜尋條件，然後再試一次。
檢視所有 7 | 類型 | 標題 | 日期 | ||
|---|---|---|---|---|
| * | Data sheet | TPS40200 Wide Input Range Non-Synchronous Voltage Mode Controller datasheet (Rev. G) | PDF | HTML | 2014年 12月 1日 |
| Selection guide | Power Management Guide 2018 (Rev. R) | 2018年 6月 25日 | ||
| Application note | Automated Frequency Response Analyzer | 2013年 10月 9日 | ||
| More literature | Исходные проекты ll | 2011年 5月 13日 | ||
| Analog Design Journal | 3Q 2010 Issue Analog Applications Journal | 2010年 8月 11日 | ||
| EVM User's guide | Using the TPS40200EVM-002 with a 24V Input (Rev. B) | 2009年 4月 7日 | ||
| More literature | TPS40200D Test Report | 2008年 2月 15日 |
設計與開發
如需其他條款或必要資源，請按一下下方的任何標題以檢視詳細頁面 (如有)。
開發板
TPS40200EVM-002 — 用於 24V 輸入的評估模組
The TPS40200EVM-002 evaluation module (EVM) uses the TPS40200 non-synchronous buck controller to provide a resistor selected 3.3 V output voltage that delivers up to 2.5 A from a 24 V input bus. The EVM operates from a single supply and uses a single P-channel power FET and Schottky (...)
使用指南: PDF
開發套件
LAUNCHXL-F28027 — C2000 Piccolo MCU F28027 LaunchPad™ 開發套件
LAUNCHXL-F28027 is a low cost evaluation and development tool for the F2802x series in the TI MCU LaunchPad ecosystem which is compatible with various plug-on BoosterPacks (suggested under the Recommended BoosterPacks in the Features section below). The LaunchPad provides a standardized and (...)
使用指南: PDF
模擬型號
TPS40200 TINA-TI Transient -5.2V Buck/Boost Reference Design
SLVM023.ZIP (135 KB) - TINA-TI Reference Design
模擬型號
TPS40200 TINA-TI AC Analysis Reference Design (Rev. D)
SLVJ005D.TSC (795 KB) - TINA-TI Reference Design
模擬型號
TPS40200 TINA-TI Transient Buck Reference Design
SLVM022.ZIP (44 KB) - TINA-TI Reference Design
模擬型號
TPS40200 Unencrypted PSpice Average Model Package (Rev. E)
SLVJ006E.ZIP (332 KB) - PSpice Model
參考設計
PMP30595 — 適用於教學用途的通用降壓轉換器參考設計
This universal buck converter reference design features a voltage mode buck converter in combination with a tiny, onboard electronics load to demonstrate the relationship in-between small-signal analysis in frequency domain (network analysis) and large signal analysis in time domain (transient (...)
參考設計
PMP7154 — TPS40200 通用非同步降壓轉換器參考設計
This reference design operates over an 8V - 16V input range and delivers 5V @ 1A at the output. This design is content from the presentation material of the TI Power Workshop. This design has been built and tested and the design files and test report are included. This is a good low cost design (...)
參考設計
PMP10074 — 參考設計 - 低雜訊 ZETA 拓撲，轉換 6V…22Vin 至 11V@500mA
This small ZETA converter works with input voltages in the range of 6V to 32V. Thank to the ZETA topology, it is able to stabilize the output voltage to 11V, which is inside the input voltage range. A SEPIC converter might be also employed at the expense of higher output ripple voltage.
參考設計
TIDM-LPBP-LEDDRIVER — 即時數位 LED 控制
The Real-time Digital LED Control reference design demonstrates the control of three boost converters to drive three LEDs (red, blue, and green) strings. This design allows development with real-time digital control of the various LEDs which makes it perfect for any industrial or automotive (...)
電路圖: PDF
參考設計
PMP4629 — 汽車應用中的安全追蹤器
This reference design supports the supply for a security tracker using the TPS40200-Q1, with the opportunity of a wide input voltage range from 8V-50V. The output can handle 4.3V up to 3A due to the non-synchronous buck controller. The reference design also allows for flexible design with a simple (...)
| 封裝 | 引腳 | 下載 |
|---|---|---|
| SOIC (D) | 8 | 檢視選項 |
| VSON (DRB) | 8 | 檢視選項 |
訂購與品質
內含資訊：
- RoHS
- REACH
- 產品標記
- 鉛塗層/球物料
- MSL 等級/回焊峰值
- MTBF/FIT 估算值
- 材料內容
- 資格摘要
- 進行中可靠性監測
內含資訊：
- 晶圓廠位置
- 組裝地點