SBAU457 October   2026

 

  1.   1
  2.   Description
  3.   Get Started
  4.   Features
  5.   Applications
  6.   6
  7. 1Evaluation Module Overview
    1. 1.1 Introduction
    2. 1.2 Kit Contents
    3. 1.3 Specifications
    4. 1.4 Device Information
  8. 2Hardware
    1. 2.1 TMAG3101-Q1 EVM Components
    2. 2.2 SCB LEDs
    3. 2.3 Hardware Jumper J7 and Resistor Configurations for Different Operating Modes
  9. 3Software
    1. 3.1 Quick Start Setup
    2. 3.2 EVM Operation
      1. 3.2.1 Setup
        1. 3.2.1.1 Driver Installation
        2. 3.2.1.2 Firmware
          1. 3.2.1.2.1 Updating Firmware on SCB
        3. 3.2.1.3 GUI Setup and Usage
          1. 3.2.1.3.1 Initial Setup
          2. 3.2.1.3.2 GUI Operation
      2. 3.2.2 Rotate and Push Demo
      3. 3.2.3 SENT and Triggered SENT Operating Modes
      4. 3.2.4 Analog Operating Mode
      5. 3.2.5 PWM Operating Mode
      6. 3.2.6 Direct EVM Serial Communication
  10. 4Hardware Design Files
    1. 4.1 Schematics
    2. 4.2 PCB Layout
    3. 4.3 Bill of Materials
  11. 5Additional Information
    1.     Trademarks
  12. 6Related Documentation
3.2.1.3.1 Initial Setup

To set up the GUI the first time, follow these steps:

  1. Make sure that the previously-mentioned driver is installed successfully to verify everything works properly.
  2. Plug the connected EVM and SCB unit to the PC and go to the GUI link provided earlier.
  3. Select the GUI Composer application window shown in Figure 3-4 to launch the GUI from the web browser.
    TMAG3101EVM GUI Composer Application Window - Replace Figure 3-4 GUI Composer Application Window - Replace
    • For first-time GUI Composer setup, follow the prompts to download the TI Cloud Agent and browser extension shown in Figure 3-5. These prompts appear after you close the README.md dialog.
    TMAG3101EVM TI Cloud Agent Figure 3-5 TI Cloud Agent
  4. Select the TMAG3101EVM icon in the GUI Composer window shown in Figure 3-4 to download the GUI offline (optional).