SBOSAM6 January   2000  – December 2024 LMC6035-Q1

PRODUCTION DATA  

  1.   1
  2. 1 Features
  3. 2 Applications
  4. 3 Description
  5. 4 Pin Configuration and Functions
  6. 5 Specifications
    1. 5.1 Absolute Maximum Ratings
    2. 5.2 ESD Ratings
    3. 5.3 Recommended Operating Conditions
    4. 5.4 Thermal Information
    5. 5.5 Electrical Characteristics
    6. 5.6 Typical Characteristics
  7. 6 Detailed Description
    1. 6.1 Overview
    2. 6.2 Functional Block Diagram
  8. 7 Application and Implementation
    1. 7.1 Application Information
      1. 7.1.1 Capacitive Load Tolerance
    2. 7.2 Typical Applications
      1. 7.2.1 Differential Driver
      2. 7.2.2 Low-Pass Active Filter
        1. 7.2.2.1 Low-Pass Frequency Scaling Procedure
      3. 7.2.3 High-Pass Active Filter
        1. 7.2.3.1 High-Pass Frequency Scaling Procedure
      4. 7.2.4 Dual-Amplifier Bandpass Filter
        1. 7.2.4.1 DABP Component Selection Procedure
    3. 7.3 Layout
      1. 7.3.1 Layout Guidelines
        1. 7.3.1.1 Printed Circuit Board (PCB) Layout for High-Impedance Work
      2. 7.3.2 Layout Example
  9. 8 Device and Documentation Support
    1. 8.1 Receiving Notification of Documentation Updates
    2. 8.2 Support Resources
    3.     Trademarks
    4. 8.3 Electrostatic Discharge Caution
    5. 8.4 Glossary
  10. 9 Revision History
  11. 10Mechanical, Packaging, and Orderable Information

DABP Component Selection Procedure

Component selection for the DABP filter is performed as follows:

  1. First choose a center frequency (fc). Figure 7-9 represents component values that were obtained from the following computation for a center frequency of 1kHz.
    Equation 12. R 2 = R 3 =   1 2 π f c C
    Given that fc = 1kHz and C (chosen) = 6.8nF:
    Equation 13. R 2 = R 3 =   1 2 π   × 1 k H z   × 6.8 n F = 23.4 k Ω
    A standard value resistor, 23.7kΩ is chosen.
  2. Then compute R1 for a desired Q (fc / BW) as follows:
    Equation 14. R 1 = Q × R 2
    Equation 15. Choosing a Q of 100, the resistor R1 can be computed as follows: R 1 = 100 × 23.7 k Ω = 2.37 M Ω