SDAA019 October   2025 AM62L

 

  1.   1
  2.   Abstract
  3.   Trademarks
  4. 1Active Power Consumption Summary
  5. 2Low Power Consumption Summary
  6. 3Introduction
    1. 3.1 Testing Conditions and Parameters
    2. 3.2 Starter Kit EVM Information
      1. 3.2.1 Starter Kit EVM Power Rails
  7. 4Power Measurement Data
    1. 4.1 Low Power Modes
      1. 4.1.1 DeepSleep
      2. 4.1.2 RTC Only Plus DDR
      3. 4.1.3 RTC Only
    2. 4.2 Core
      1. 4.2.1 Dhrystone
      2. 4.2.2 Whetstone
      3. 4.2.3 Stress-ng
      4. 4.2.4 CoreMark-Pro
    3. 4.3 Memory and Data Storage
      1. 4.3.1 Stream
      2. 4.3.2 Memtester
      3. 4.3.3 eMMC Read & Write
    4. 4.4 Networking & Cryptography
      1. 4.4.1 OpenSSL
      2. 4.4.2 Ethernet Throughput
    5. 4.5 Application Demos
      1. 4.5.1 LVGL Demo
      2. 4.5.2 Audio Playback Demo
  8. 5References
  9. 6Appendix
    1. 6.1 How to Change LPDDR4 Data Rate
    2. 6.2 How to Measure On-Die Temperature

6.1 How to Change LPDDR4 Data Rate

  1. Go to dev.ti.com/sysconfig

  2. Under 'Software Product', select 'DDR Configuration ... AM62Lx'

  3. Under 'Device', select AM62L

  4. Change the speed from 800MHz to 400MHz which is the DDR clock speed.

  5. Follow the instructions in the SYSCONFIG Tool on implementing the change.

  6. Re-build U-Boot after implementing the change for a new TF-A