SLAU213B March   2007  – August 2018

 

  1.   MSP430FG4618/F2013 Experimenter Board (MSP‑EXP430FG4618)
    1.     Trademarks
    2. 1 Devices Supported
    3. 2 If You Need Assistance
    4. 3 Required Tools
    5. 4 Functional Overview
    6. 5 Hardware Installation
    7. 6 Hardware Overview
      1. 6.1 Interfaces
        1. 6.1.1 4-Mux LCD Display
        2. 6.1.2 Momentary-On Push Buttons
        3. 6.1.3 Light Emitting Diodes (LEDs)
        4. 6.1.4 Buzzer
        5. 6.1.5 Single-Touch Sensing Interface
      2. 6.2 Communication Peripherals
        1. 6.2.1 Wireless Evaluation Module Interface
        2. 6.2.2 RS-232
        3. 6.2.3 I2C and SPI
      3. 6.3 Analog Signal Chain
        1. 6.3.1 Microphone
        2. 6.3.2 Analog Filters
        3. 6.3.3 Analog Output
      4. 6.4 System Clocks
        1. 6.4.1 MSP430F2013 Clock Sources
        2. 6.4.2 MSP430FG4618 Clock Sources
      5. 6.5 Jumper Configurations
        1. 6.5.1 Jumper Locations and Settings
    8. 7 Frequently Asked Questions
    9. 8 Schematic
    10. 9 References
  2.   Revision History

3 Required Tools

A flash emulation tool for MSP430 MCUs (MSP-FET) is required to download code and debug the MSP430FG4618 and MSP430F2013. Two separate JTAG headers are available, supporting independent debug environments. The MSP430FG4618 uses the standard 4-wire JTAG connection while the MSP430F2013 uses the Spy-Bi-wire (2-wire) JTAG interface allowing all port pins to be used during debug. For more details on the flash emulation tool, see the MSP Debuggers User's Guide.