SLAU888 may   2023 AFE882H1

 

  1.   AFE882H1 Evaluation Module
  2.   Trademarks
  3. 1Overview
    1. 1.1 Kit Contents
    2. 1.2 Related Documentation From Texas Instruments
  4. 2System Setup
    1. 2.1 Software Setup
    2. 2.2 Hardware Setup
      1. 2.2.1 Electrostatic Discharge Caution
      2. 2.2.2 Power Configuration and Jumper Settings
      3. 2.2.3 Connecting the Hardware
        1. 2.2.3.1 Power Configuration
        2. 2.2.3.2 External SPI and UART Controllers
  5. 3Detailed Description
    1. 3.1 Hardware Description
      1. 3.1.1 Theory of Operation
      2. 3.1.2 Signal Definitions
      3. 3.1.3 XTR305 Configuration
    2. 3.2 Software Description
      1. 3.2.1 Starting the Software
      2. 3.2.2 Software Features
        1. 3.2.2.1 High Level Configuration Page
        2. 3.2.2.2 AFE882H1 Register Page
  6. 4Schematics, PCB Layout, and Bill of Materials
    1. 4.1 Board Schematic
    2. 4.2 PCB Components Layout
    3. 4.3 Bill of Materials

2.2.3.2 External SPI and UART Controllers

To use an external SPI or UART controller with the EVM board, disconnect the connections from the FTDI controller to the devices at the level shifters. To disable the level shifters, use the J25 header and add jumpers from SPI_EN, UART_EN, and RESET_EN to ground. After the level shifters are disabled, connect an external controller to pin headers at J9, J15, and J16 to control the AFE882H1 and XTR305.