SLUUB60B May   2015  – August 2021 TPS544B25 , TPS544C25

 

  1.   Trademarks
  2. 1 Introduction
  3. 2 Description
    1. 2.1 Typical End-User Applications
    2. 2.2 EVM Features
  4. 3 EVM Electrical Performance Specifications
  5. 4 Schematic
  6. 5 Test Setup
    1. 5.1 Test and Configuration Software
      1. 5.1.1 Description
      2. 5.1.2 Features
    2. 5.2 Test Equipment
    3. 5.3 The PWR-681EVM
    4. 5.4 List of Test Points, Jumpers ans Switch
  7. 6 EVM Configuration Using the Fusion GUI
    1. 6.1 Configuration Procedure
  8. 7 Test Procedure
    1. 7.1 Line/Load Regulation Measurement Procedure
    2. 7.2 Efficiency
    3. 7.3 Bode Plot Measurement Procedure
    4. 7.4 Equipment Shutdown
  9. 8 Performance Data and Typical Characteristic Curves
    1. 8.1  Efficiency
    2. 8.2  Load Regulation
    3. 8.3  Line Regulation
    4. 8.4  Transient Response
    5. 8.5  Output Ripple
    6. 8.6  Control On
    7. 8.7  Control Off
    8. 8.8  Overcurrent Protection
    9. 8.9  Control Loop Bode Plot
    10. 8.10 Thermal Image
  10. 9 Fusion GUI
  11. 10EVM Assembly Drawing and PCB Layout
  12. 11List of Materials
  13. 12Revision History

5.1.1 Description

The Fusion Digital Power Designer is the graphical user interface (GUI) used to configure and monitor the Texas Instruments TPS544B25 or TPS544C25 power converter installed on this evaluation module. The application uses the PMBus protocol to communicate with the controller over serial bus by way of a TI USB adapter. This adapter can be purchased at http://www.ti.com/tool/usb-to-gpio.

Note:

The TI USB adapter must be purchased separately. It is not included with this EVM kit.