SLUUCS5A january   2023  – july 2023 UCC14141-Q1

 

  1.   1
  2.   Abstract
  3.   Trademarks
  4. 1Introduction
    1. 1.1 U1 Component Selection
    2. 1.2 Pin Configuration and Functions
  5. 2Description
    1. 2.1 EVM Electrical Performance Specifications
  6. 3Schematic
  7. 4EVM Setup and Operation
    1. 4.1 Recommended Test Equipment
    2. 4.2 External Connections for Easy Evaluation
    3. 4.3 Powering the EVM
      1. 4.3.1 Power on for Start-up
      2. 4.3.2 Power off for Shutdown
    4. 4.4 EVM Test Points
    5. 4.5 Probing the EVM
  8. 5 Performance Data
    1. 5.1  Efficiency Data
    2. 5.2  Regulation Data
    3. 5.3  Steady State Input Current
    4. 5.4  Start-up Waveforms
    5. 5.5  Inrush Current
    6. 5.6  AC Ripple Voltage
    7. 5.7  EN-to-/PG Timing
    8. 5.8  RLIM
    9. 5.9  Fault Protection
      1. 5.9.1 Output UVLO
      2. 5.9.2 Output OVP
    10. 5.10 Shutdown
    11. 5.11 Thermal Performance
  9. 6Assembly and Printed Circuit Board (PCB) Layers
  10. 7Bill of Materials (BOM)
  11. 8Revision History

1.1 U1 Component Selection

The UCC14141-Q1 is the default IC used in the UCC14141EVM-068 but any of the alternate versions listed in Table 1-1 can be used for evaluation. Each of the component versions listed in Table 1-1 are pin-to-pin compatible, functionally equivalent, drop in replacements with respect to one another. Component part numbers beginning with “P” indicate pre-production material but are the same IC as “non-P” marked components.

Table 1-1 UCC1414x-Q1 Version Differences
General Part Number Orderable Part Number Isolation/Surge/Working Voltage
UCC14141-Q1 UCC14141QDWNQ1 5 kVRMS/10 kVPK/1 kVRMS
PUCC14141-Q1 PUCC14141QDWNQ1 5 kVRMS/10 kVPK/1 kVRMS
UCC14140-Q1 UCC14140QDWNQ1 3 kVRMS/6.5 kVPK/850 kVRMS
PUCC14140-Q1 PUCC14140QDWNQ1 3 kVRMS/6.5 kVPK/850 kVRMS

If U1 replacement is required, then TI recommends to always use best practice soldering techniques. Techniques can include taking appropriate ESD precautions and having qualified personnel, skilled at surface mount soldering and board level rework, removing and installing U1. Visually verify the desired UCC1414x-Q1 component version is properly installed in the EVM. If rework on U1 has previously been performed, then visually verify correct orientation of U1 according to Figure 1-1. The pin 1 identifying dot on top of the IC package is oriented at the top left according to Figure 1-1.