SLUUD60C October   2024  – April 2026

 

  1.   1
  2.   Description
  3.   Get Started
  4.   Features
  5.   Applications
  6.   6
  7. 1Evaluation Module Overview
    1. 1.1 Introduction
    2. 1.2 Kit Contents
    3. 1.3 Specification
    4. 1.4 Device Information
    5. 1.5 General Texas Instruments High Voltage Evaluation (TI HV EVM) User Safety Guidelines
  8. 2Hardware
    1. 2.1 Using the EVM on a Load with USB-C PD Communication
    2. 2.2 Using the EVM on a Load Without USB-C PD Communication
  9. 3Implementation Results
    1. 3.1 Electrical Performance Specifications
    2. 3.2 Test Setup
      1. 3.2.1 Test Setup Requirements
      2. 3.2.2 Test Setup Diagram
      3. 3.2.3 Test Points
    3. 3.3 Performance Data and Typical Characteristic Curves
      1. 3.3.1  Efficiency Result of 4-Point Average at 24VOUT
      2. 3.3.2  Efficiency Result of 4-Point Average on 20VOUT
      3. 3.3.3  Efficiency Result of 4-Point Average at 15VOUT
      4. 3.3.4  Efficiency Result of 4-Point Average at 12VOUT
      5. 3.3.5  Efficiency Result of 4-Point Average at 9VOUT
      6. 3.3.6  Efficiency Result of 4-Point Average at 5VOUT
      7. 3.3.7  Efficiency Typical Results
      8. 3.3.8  Output Characteristics
      9. 3.3.9  Startup Waveforms
      10. 3.3.10 Key Switching Waveforms
      11. 3.3.11 Switching Frequency vs Load
      12. 3.3.12 Output Ripple Voltage
      13. 3.3.13 Load Transient Response
      14. 3.3.14 Line Transient Response
      15. 3.3.15 Surge Test
      16. 3.3.16 Short Term Overload Operation
      17. 3.3.17 CCM operation
      18. 3.3.18 Thermal Images at Full Load (20V and 3.25A)
  10. 4Hardware Design Files
    1. 4.1 Schematics
    2. 4.2 PCB Layouts
    3. 4.3 Transformer Details
      1. 4.3.1 RLTI-1464 (RENCO)
    4. 4.4 Bill of Materials
  11. 5Additional Information
    1.     Trademarks
  12. 6Revision History

3.2.3 Test Points

Table 3-2 Input/Output Terminals and Test Point Functions
Terminals and TEST POINTS

DESCRIPTION

J1

USB-C terminal

J2

AC voltage input terminal

LINE

Test point for AC input - Line

NEUTRAL

Test point for AC input - Neutral

PGND, PGND1

Test points for primary ground

VBLK

Test point for bulk capacitor voltage

FB

Test point for FB pin

HV

Test point for HV pin

SOURCE

Test point for SR FET source

GATE

Test point for SR FET gate

SGND

Test point for secondary ground

VOUT

Test point for converter output voltage

VBUS

Test point for bus voltage at output side

RTN

Test point for return line at output side