SLUUD62B September   2025  – May 2026

 

  1.   1
  2.   Description
  3.   Get Started
  4.   Features
  5.   Applications
  6.   6
  7. 1Evaluation Module Overview
    1. 1.1 Introduction
    2. 1.2 Kit Contents
    3. 1.3 Specifications
    4. 1.4 Device Information
  8. 2Hardware
    1. 2.1 I/O Information
    2. 2.2 Jumper Information
    3. 2.3 Equipment
    4. 2.4 Hardware Setup
  9. 3Software
    1. 3.1 Software Setup
      1. 3.1.1 BQSTUDIO
      2. 3.1.2 TI-CHARGER-GUI
    2. 3.2 Test Procedure
      1. 3.2.1 Initial Power Up
      2. 3.2.2 I2C Register Setup
      3. 3.2.3 Forward/Charge/Sink Mode Verification
      4. 3.2.4 Reverse/OTG/Source Mode Verification
      5. 3.2.5 Helpful Tips
  10. 4Hardware Design Files
    1. 4.1 Schematics
    2. 4.2 PCB Layout
      1. 4.2.1 PCB Layout Guidelines
    3. 4.3 Bill of Materials (BOM)
  11. 5Additional Information
    1.     Trademarks
  12. 6Revision History

4.1 Schematics

BQ25690EVM BQ25690EVM BMS083B Schematic Page 1 Figure 4-1 BQ25690EVM BMS083B Schematic Page 1
Note1: Only required if hot plugging an input source > 1/2*40V absolute maximum (20V) on VIN.
BQ25690EVM BQ25690EVM BMS083B Schematic Page 2 Figure 4-2 BQ25690EVM BMS083B Schematic Page 2