SLVUC27 January   2021 TPS61094


  1.   Trademarks
  2. 1Introduction
    1. 1.1 Performance Specification
    2. 1.2 Modification
  3. 2Connector, Test Point and Jumper Descriptions
    1. 2.1 Connector and Test Point Descriptions
    2. 2.2 Jumper Configuration
      1. 2.2.1 Boost Converter with Bypass
      2. 2.2.2 Boost Converter with Automatic Buck or Boost Function
  4. 3Schematic, Bill of Materials, and Board Layout
    1. 3.1 Schematics
    2. 3.2 Bill of Materials
    3. 3.3 PCB Layouts

Boost Converter with Bypass

In this section, it shows how to set the EVM to support Boost converter with bypass application. The sketch schematic is shown in Figure 2-1, while the jumper configuration is shown in Table 2-2

GUID-20200923-CA0I-LQMF-2RW4-MSW23SKQWVDD-low.gif Figure 2-1 Boost Converter with Bypass
Table 2-2 Jumpers Configuration for Boost Converter with Bypass
Reference Designator Description Configuration
JP1, JP2 Short 1-2 :connect the SUP pin to the Vin port
Short 2-3: connect the SUP pin to the SUP port
Short 1-2
JP3 Sup termination voltage selection -
JP4 Changing current selection -
JP5 Output voltage target selection At mark 3.6 V
J11, J12 Operating mode selection pin. The MODE pin and EN pin work together to set device operation mode. Set High to select auto Buck or boost mode