SLVUCG9 October   2022 TPS36-Q1

 

  1.   Abstract
  2. 1Trademarks
  3. 2Introduction
    1. 2.1 Related Documentation
  4. 3Schematic, Bill of Materials, and Layout
    1. 3.1 TPS36Q1EVM Schematic
    2. 3.2 TPS36Q1EVM Bill of Materials
    3. 3.3 Layout and Component Placement
  5. 4EVM Connectors
    1. 4.1 EVM Jumpers
    2. 4.2 EVM Test Points
  6. 5EVM Setup and Operation
    1. 5.1 Input Power (VDD)
    2. 5.2 RESET
    3. 5.3 Manual Reset (MR)
    4. 5.4 SET0 and SET1
    5. 5.5 Watchdog Enable (WD_EN)
    6. 5.6 Watchdog Input (WDI)
    7. 5.7 Watchdog Output (WDO)
    8. 5.8 CRST
    9. 5.9 CWD
  7. 6EVM Performance Results
  8. 7Revision History

5.4 SET0 and SET1

The function of the SETx pins will vary based on the device used in the EVM. Please refer to the device data sheet for the functionality. Drive SETx pins to logic 1 (connect to VDD) or logic 0 (connect to GND) as per the device pinout and functionality requirements. Refer to Tables 4-1, 4-2, 4-3, and 4-4 for suggested jumper connections.