SLVUCT6 February   2024 TPS61299

 

  1.   1
  2.   Description
  3.   Features
  4.   Applications
  5.   5
  6. 1Evaluation Module Overview
    1. 1.1 Introduction
    2. 1.2 Kit Contents
    3. 1.3 Specification
    4. 1.4 Device Information
  7. 2Hardware
    1. 2.1 Power Requirements
    2. 2.2 Setup
  8. 3Hardware Design Files
    1. 3.1 Schematic
    2. 3.2 PCB Layout
    3. 3.3 Bill of Materials
  9. 4Additional Information
    1.     Trademarks

2.2 Setup

Jumper Description
J1-VIN Input voltage positive connection.
J1-GND Input voltage negative connection.
J1-S+ Input voltage positive sensing node for measuring efficiency.
J1-S- Input voltage negative sensing node for measuring efficiency.
J2 EN pin input jumper. Place a jumper across EN and ON to turn on the IC. Place a jumper across EN and OFF to turn off the IC. Output voltage return connection.
J3 AVIN selector. Place a jumper across AVIN and PVIN to share the same power input and signal input. Place a jumper across AVIN and AUX to separate the signal input and power input.
J4-VOUT Output voltage positive connection.
J4-GND Output voltage negative connection.
J4-S+ Output voltage positive sensing node for measuring efficiency.
J4-S- Output voltage negative sensing node for measuring efficiency.
TP1 Auxiliary signal input.
SW Test point to measure SW pin waveform.