SLVUE59 September   2026

 

  1.   1
  2.   Description
  3.   Get Started
  4.   Features
  5.   Applications
  6.   6
  7. 1Evaluation Module Overview
    1. 1.1 Introduction
    2. 1.2 Kit Contents
    3. 1.3 Specification
    4. 1.4 Device Information
    5. 1.5 General Texas Instruments High Voltage Evaluation (TI HV EVM) Guidelines
  8. 2Hardware
    1. 2.1 Hardware Overview
    2. 2.2 Interfaces
      1. 2.2.1 EVM Power Supply Input
      2. 2.2.2 Voltage Monitor Input
      3. 2.2.3 Current Monitor Input
      4. 2.2.4 Voltage and Current Monitor Outputs
    3. 2.3 Test Points
  9. 3Implementation Results
    1. 3.1 Evaluation Procedure
      1. 3.1.1 Minimum Equipment Required for Full Scale testing
      2. 3.1.2 Voltage Test Procedure
      3. 3.1.3 Current Test Procedure
      4. 3.1.4 Notes on Voltage and Current Measurements
      5. 3.1.5 Calculations
      6. 3.1.6 Voltage and Current Test Results
      7. 3.1.7 Thermal Images
      8. 3.1.8 EMI Test Results
  10. 4Hardware Design Files
    1. 4.1 Schematics
    2. 4.2 PCB Layouts
    3. 4.3 Bill of Materials (BOM)
  11. 5Compliance Information
    1. 5.1 Compliance and Certifications
  12. 6Additional Information
    1. 6.1 Trademarks

2.3 Test Points

There are six test points available on the EVM. TP1 and TP6 are both user-side ground. TP2 is provided to monitor the DIAG pin of the AMC4330R. TP3 and TP4 are the current and voltage monitoring points. TP5 is provided to monitor DVDD applied to the EVM. Each test point is labeled with the function of the test point.