TIDT349A January   2024  – December 2024

 

  1.   1
  2.   Description
  3.   Features
  4.   Applications
  5. 1Test Prerequisites
    1. 1.1 Voltage and Current Requirements
    2. 1.2 Required Equipment
    3. 1.3 Considerations
    4. 1.4 Dimensions
    5. 1.5 Test Setup
  6. 2Testing and Results
    1. 2.1 Efficiency Graphs
    2. 2.2 Efficiency Data
    3. 2.3 Thermal Images
  7. 3Waveforms
    1. 3.1 Charge Mode Start-Up Waveform
    2. 3.2 OTG Mode Start-Up Waveform
    3. 3.3 Voltage Transition at OTG Mode
    4. 3.4 Ripple and Noise at OTG Mode
    5. 3.5 Load Transients at OTG Mode
    6. 3.6 Switching Waveform
    7. 3.7 Overcurrent Protection at OTG Mode
    8. 3.8 Short-Circuit Protection at OTG Mode
    9. 3.9 Short-Circuit Protection at Charge Mode
  8. 4Trademarks

2.1 Efficiency Graphs

Figure 2-1 shows the sink mode efficiency across different Vsys voltage and battery cell conditions. The fast charge current limit is set to 3A and input current limit is set to 3A for 5V, 9V, and 15V input source, and 5A for a 20V input source. At OTG mode, Figure 2-3 shows the efficiency test which was performed at the 10S battery setting.

PMP41062 Charge Mode Efficiency Across Vsys and VbatFigure 2-1 Charge Mode Efficiency Across Vsys and Vbat
PMP41062 Power Loss vs Vsys and VbatFigure 2-2 Power Loss vs Vsys and Vbat
PMP41062 OTG Mode 20V at 5A Full-Load Efficiency Vbat = 40VFigure 2-3 OTG Mode 20V at 5A Full-Load Efficiency Vbat = 40V
PMP41062 OTG Mode Output Voltage Regulation vs LoadFigure 2-4 OTG Mode Output Voltage Regulation vs Load