BQ27Z855

ACTIVO

Detalles del producto

Cell chemistry Li-Ion/Li-Polymer, LiFePO4, NCM Number of series cells Single Cell Communication interface I2C Battery capacity (min) (mAh) 100 Battery capacity (max) (mAh) 32000 Implementation Pack External capacity indication None Features Configurable current limiter, Dynamic Z-Track™ technology, ECC authentication, Integrated Protector, SHA-256 Authentication Operating temperature range (°C) -40 to 85 Rating Catalog
Cell chemistry Li-Ion/Li-Polymer, LiFePO4, NCM Number of series cells Single Cell Communication interface I2C Battery capacity (min) (mAh) 100 Battery capacity (max) (mAh) 32000 Implementation Pack External capacity indication None Features Configurable current limiter, Dynamic Z-Track™ technology, ECC authentication, Integrated Protector, SHA-256 Authentication Operating temperature range (°C) -40 to 85 Rating Catalog
DSBGA (YAH) 15 5.4488 mm² (2.78 mm × 1.96 mm)
  • Fully integrated battery fuel gauge, linear battery charger, protector, and authenticator
  • Battery chemistries supported include Li-ion with LCO, NMC, or LFP cathodes
  • Battery fuel gauging based on patented Dynamic Z-Track technology
    • Automatically adjusts for aging, temperature, and rate-induced effects on the battery
  • Fully featured battery linear charger
    • CC/CV charging up to 2A with JEITA-compliant integrated Advanced Charge Algorithm (ACA)
    • Dynamic Power Path Management
      • MINSYS mode to ensure system voltage does not drop below target threshold while charging with a weak input
      • SUPPLEMENT mode with ultra fast switching time to ensure system does not brown out during loads while charging
    • Ideal diode (ID) mode during discharge to prevent voltage drop to system load
    • PACK+ terminal voltage tolerance of +24V with 1kΩ RPACK value
  • High-accuracy analog front end with two independent ADCs:
    • 18-bit low offset delta-sigma ADC for Coulomb counting with ±100mV input range
    • 16-bit delta-sigma ADC for cell voltage and internal and external temperature sensors
  • Programmable safety and protection:
    • Hardware-level protections
      • Over Voltage Protection (OVP)
      • Under Voltage Protection (UVP)
      • Over Current Charging (OCC)
      • Over Current Discharging (OCD)
      • Short Circuit Discharging (SCD)
    • Firmware-level protections
      • OVP, UVP, OCC, and OCD
      • Under Temperature (UT)
      • Over Temperature (OT)
      • FET Failure (FETF)
      • Charge Timeout (CTO)
  • ECC ECDSA authentication support with secure memory
  • True zero-volt charging to support dead battery charging
  • Integrated RTC with calendar and time of day
  • Ultra-compact, 15-ball DSBGA package (YAH)
  • Fully integrated battery fuel gauge, linear battery charger, protector, and authenticator
  • Battery chemistries supported include Li-ion with LCO, NMC, or LFP cathodes
  • Battery fuel gauging based on patented Dynamic Z-Track technology
    • Automatically adjusts for aging, temperature, and rate-induced effects on the battery
  • Fully featured battery linear charger
    • CC/CV charging up to 2A with JEITA-compliant integrated Advanced Charge Algorithm (ACA)
    • Dynamic Power Path Management
      • MINSYS mode to ensure system voltage does not drop below target threshold while charging with a weak input
      • SUPPLEMENT mode with ultra fast switching time to ensure system does not brown out during loads while charging
    • Ideal diode (ID) mode during discharge to prevent voltage drop to system load
    • PACK+ terminal voltage tolerance of +24V with 1kΩ RPACK value
  • High-accuracy analog front end with two independent ADCs:
    • 18-bit low offset delta-sigma ADC for Coulomb counting with ±100mV input range
    • 16-bit delta-sigma ADC for cell voltage and internal and external temperature sensors
  • Programmable safety and protection:
    • Hardware-level protections
      • Over Voltage Protection (OVP)
      • Under Voltage Protection (UVP)
      • Over Current Charging (OCC)
      • Over Current Discharging (OCD)
      • Short Circuit Discharging (SCD)
    • Firmware-level protections
      • OVP, UVP, OCC, and OCD
      • Under Temperature (UT)
      • Over Temperature (OT)
      • FET Failure (FETF)
      • Charge Timeout (CTO)
  • ECC ECDSA authentication support with secure memory
  • True zero-volt charging to support dead battery charging
  • Integrated RTC with calendar and time of day
  • Ultra-compact, 15-ball DSBGA package (YAH)

The Texas Instruments BQ27Z855 Dynamic Z-Trackgas gauge solution is a fully integrated, accurate 1-series cell gas gauge, JEITA-compliant linear battery charger, protection, and authentication solution.

The BQ27Z855 gas gauge communicates through an I2C compatible interface and combines an ultra-low power ARM M0 RISC processor, high accuracy analog measurement capabilities, integrated flash memory, high-side NMOS FET drivers, and ECC ECDSA authentication to provide a complete, high-performance battery management solution.

The Texas Instruments BQ27Z855 Dynamic Z-Trackgas gauge solution is a fully integrated, accurate 1-series cell gas gauge, JEITA-compliant linear battery charger, protection, and authentication solution.

The BQ27Z855 gas gauge communicates through an I2C compatible interface and combines an ultra-low power ARM M0 RISC processor, high accuracy analog measurement capabilities, integrated flash memory, high-side NMOS FET drivers, and ECC ECDSA authentication to provide a complete, high-performance battery management solution.

Descargar Ver vídeo con transcripción Video

Documentación técnica

No se encontraron resultados. Borre su búsqueda y vuelva a intentarlo.
Ver todo 6
Documentación principal Tipo Título Opciones de formato Descargar la versión más reciente en inglés Fecha
* Hoja de datos BQ27Z855 Dynamic Z-Track Battery Fuel Gauge with Integrated JEITA-Compliant Linear Battery Charger, Protection, and Authentication for 1-Series Cell Battery Packs datasheet (Rev. A) PDF | HTML 13/11/2026
* Guía del usuario BQ27Z855 Technical Reference Manual (Rev. A) PDF | HTML 21/07/2026
Nota sobre la aplicación Dynamic Z-Track™ Technology: An Advanced Battery Gauging Algorithm for Dynamic Load Applications (Rev. A) PDF | HTML 15/07/2025
Nota sobre la aplicación Implementation of Elliptic Curve Cryptography Authentication on TI Battery Fuel Gauges PDF | HTML 28/05/2025
Nota sobre la aplicación How to Create and Program Authentication Keys into TI Battery Fuel Gauges PDF | HTML 5/03/2025
Nota sobre la aplicación Battery Gauging Algorithm Comparison PDF | HTML 4/12/2023

Diseño y desarrollo

Para conocer los términos adicionales o los recursos necesarios, haga clic en cualquier título de abajo para ver la página de detalles cuando esté disponible.

Placa de evaluación

BQ27Z855EVM — Módulo de evaluación BQ27Z855

El módulo de evaluación (EVM) BQ27Z855 es una placa de sistema creada para permitir a los usuarios evaluar la funcionalidad del indicador de combustible BQ27Z855 en su sistema. El EVM BQ27Z855 es adecuado para aplicaciones en las que la batería es de celda 1-S, es decir, una celda en serie. El EVM (...)

Guía del usuario: PDF | HTML
Productos y hardware compatibles
En inventario
Límite:
??asset.out-of-stock-ti_es_MX??
No disponible
Software de aplicación y estructura

BQSTUDIO-TEST — Battery Management Studio (bqStudio) Software – Beta version downloads

Battery Management Studio (bqStudio) ofrece un conjunto completo de herramientas robustas para ayudar con el proceso de evaluación, diseño, configuración, prueba o utilización de productos de gestión de baterías de TI. Esto incluye funciones que (...)

Productos y hardware compatibles
Firmware

BQ27Z855-FW — BQ27Z855 device firmware

Productos y hardware compatibles
GUI para el módulo de evaluación (EVM)

BQSTUDIO-GUI — Battery Management Studio (bqStudio) Software - Web Based Version

Battery Management Studio (bqStudio) ofrece un conjunto completo de herramientas robustas para ayudar con el proceso de evaluación, diseño, configuración, prueba o utilización de productos de gestión de baterías de TI. Esto incluye funciones que proporcionan acceso completo a registros y memoria de (...)

Productos y hardware compatibles
Herramienta de programación de software

BQ-BMS-PROGRAMMER-SW — Command line programmers for BQ products

El kit de desarrollo de software (SDK) BQ-BATTERY-PROGRAMMER-SW es una colección de herramientas de línea de comandos de software robustas que ayudan con el proceso de programación, prueba o ensamblaje de paquetes que utilizan productos de administración de baterías de TI. Los ejecutables de este (...)

Productos y hardware compatibles
Encapsulado Pines Símbolos CAD, huellas y modelos 3D
DSBGA (YAH) 15 Ultra Librarian

Pedidos y calidad

Los productos recomendados pueden tener parámetros, módulos de evaluación o diseños de referencia relacionados con este producto de TI.

Soporte y capacitación

Foros de TI E2E™ con asistencia técnica de los ingenieros de TI

El contenido lo proporcionan “tal como está” TI y los colaboradores de la comunidad y no constituye especificaciones de TI. Consulte los términos de uso.

Si tiene alguna pregunta sobre calidad, encapsulados o pedido de productos de TI, consulte el servicio de asistencia de TI. ​​​​​​​​​​​​​​

Videos