LM117HVQML
- Available with Radiation Ensured
- Total Ionizing Dose 100 krad(Si)
- Low Dose Rate Qualified 100 krad(Si)
- Adjustable Output down to 1.2V
- Specified 0.5A or 1.5A Output Current
- Line Regulation Typically 0.01%/V
- Load Regulation Typically 0.1%
- Current Limit Constant with Temperature
- Eliminates the Need to Stock Many Voltages
- 80 dB Ripple Rejection
- Output is Short-Circuit Protected
All trademarks are the property of their respective owners.
The LM117HV are adjustable 3-terminal positive voltage regulators capable of supplying either 0.5A or 1.5A over a 1.2V to 57V output range. They are exceptionally easy to use and require only two external resistors to set the output voltage. Further, both line and load regulation are better than standard fixed regulators.
In addition to higher performance than fixed regulators, the LM117HV series offers full overload protection available only in IC's. Included on the chip are current limit, thermal overload protection and safe area protection. All overload protection circuitry remains fully functional even if the adjustment terminal is disconnected.
Normally, no capacitors are needed unless the device is situated more than 6 inches from the input filter capacitors in which case an input bypass is needed. An optional output capacitor can be added to improve transient response. The adjustment terminal can be bypassed to achieve very high ripple rejections ratios which are difficult to achieve with standard 3-terminal regulators.
Besides replacing fixed regulators, the LM117HV is useful in a wide variety of other applications. Since the regulator is “floating” and sees only the input-to-output differential voltage, supplies of several hundred volts can be regulated as long as the maximum input to output differential is not exceeded, i.e. do not short the output to ground.
Also, it makes an especially simple adjustable switching regulator, a programmable output regulator, or by connecting a fixed resistor between the adjustment and output, the LM117HV can be used as a precision current regulator. Supplies with electronic shutdown can be achieved by clamping the adjustment terminal to ground which programs the output to 1.2V where most loads draw little current.
기술 자료
유형 | 직함 | 날짜 | ||
---|---|---|---|---|
* | Data sheet | LM117HVQML 3-Terminal Adjustable Regulator datasheet (Rev. D) | 2013/04/16 | |
* | SMD | LM117HVQML SMD 5962-07229 | 2016/06/21 | |
Application note | A Topical Index of TI LDO Application Notes (Rev. F) | 2019/06/27 | ||
Application note | AN-103 LM340 Series Three Terminal Positive Regulators (Rev. A) | 2013/05/06 | ||
Application note | AN-1148 Linear Regulators: Theory of Operation and Compensation (Rev. B) | 2013/05/06 | ||
Application note | Method For Cal Output Voltage Tolerances in Adj Regs (Rev. A) | 2013/05/05 | ||
More literature | Die D/S LM117HVKG MD8 3-Terminal Adj Regulator | 2012/09/13 | ||
Application note | Packaging Limits Range of Linear Regulators | 2010/05/08 | ||
Application note | Digital Designer's Guide to Linear Voltage Regulators & Thermal Mgmt (LDO) (Rev. A) | 2008/06/04 | ||
Application note | Understanding the Terms and Definitions of LDO Voltage Regulators | 1999/10/21 |
설계 및 개발
추가 조건 또는 필수 리소스는 사용 가능한 경우 아래 제목을 클릭하여 세부 정보 페이지를 확인하세요.
패키지 | 핀 | CAD 기호, 풋프린트 및 3D 모델 |
---|---|---|
CFP (NAC) | 16 | Ultra Librarian |
DIESALE (Y) | — | |
TO-CAN (K) | 2 | Ultra Librarian |
TO-CAN (NDT) | 3 | Ultra Librarian |
주문 및 품질
- RoHS
- REACH
- 디바이스 마킹
- 납 마감/볼 재질
- MSL 등급/피크 리플로우
- MTBF/FIT 예측
- 물질 성분
- 인증 요약
- 지속적인 신뢰성 모니터링
- 팹 위치
- 조립 위치