首頁 電源管理 DC/DC 切換穩壓器 DC/DC 控制器
首頁
電源管理
DC/DC 切換穩壓器
DC/DC 控制器
最新

LM5125A-Q1

現行

具有 VOUT 追蹤的大範圍 VIN、2.2MHz 雙相位升壓控制器

立即訂購
產品規格表

LM5125A-Q1

現行
產品規格表 立即訂購

產品詳細資料

Rating Automotive Topology Boost Controller Vin (max) (V) 45 Vin (min) (V) 2.5 Vout (max) (V) 60 Vout (min) (V) 6 Control mode current mode control Features Adjustable current limit, Adjustable soft start, Adjustable switching frequency, Analog current monitor, Automatic Light Load Management, Automotive load dump, Bypass Mode, Chip-enable control pin, Cycle-by-cycle overcurrent protection, External Sync, Fixed PWM Mode, Multiphase, Overcurrent protection with adjustable delay, Power good, Programmable dead time, Spread Spectrum, Tracking EMI features Frequency Dithering, Spread Spectrum Duty cycle (max) (%) 99.2 Iq (typ) (A) 0.00025 TI functional safety category Functional Safety-Capable Operating temperature range (°C) -40 to 150
Rating Automotive Topology Boost Controller Vin (max) (V) 45 Vin (min) (V) 2.5 Vout (max) (V) 60 Vout (min) (V) 6 Control mode current mode control Features Adjustable current limit, Adjustable soft start, Adjustable switching frequency, Analog current monitor, Automatic Light Load Management, Automotive load dump, Bypass Mode, Chip-enable control pin, Cycle-by-cycle overcurrent protection, External Sync, Fixed PWM Mode, Multiphase, Overcurrent protection with adjustable delay, Power good, Programmable dead time, Spread Spectrum, Tracking EMI features Frequency Dithering, Spread Spectrum Duty cycle (max) (%) 99.2 Iq (typ) (A) 0.00025 TI functional safety category Functional Safety-Capable Operating temperature range (°C) -40 to 150
VQFN (RHB) 32 25 mm² 5 x 5
  • AEC-Q100 qualified for automotive applications
    • Temperature grade 1: TA = –40°C to +125°C
  • Functional Safety-Capable
  • Input voltage 4.5V to 42V
    • Minimum 2.5V for V(BIAS) ≥ 4.5V or VOUT ≥ 6V
  • Output Voltage 6V to 60V
    • 2% accuracy, internal feedback resistors
    • Bypass operation for VI > VOUT
    • Dynamic output voltage tracking
      • Digital PWM tracking (DTRK)
      • Analog tracking (ATRK)
    • Overvoltage protection (64V, 50V, 35V, 28.5V)
  • Low shutdown IQ of 2µA
  • Low operating IQ of 1.4mA
  • Stacking with interleaved multiphase operation
    • Up to 4-phases without external clock
  • Switching frequency from 100kHz to 2.2MHz
    • Synchronization to external clock (SYNCIN)
    • Dynamically selectable switching modes (FPWM, diode emulation)
    • Spread spectrum (DRSS)
  • Selectable dead time (14ns to 200ns)
  • Current sense resistor or DCR sensing
  • Average inductor current monitor
  • Average input current limit
    • Programmable current limit
    • Selectable delay time
  • Power-good indicator
  • Programmable VI undervoltage lockout (UVLO)
  • Lead-less VQFN-32 package with wettable flanks
  • AEC-Q100 qualified for automotive applications
    • Temperature grade 1: TA = –40°C to +125°C
  • Functional Safety-Capable
  • Input voltage 4.5V to 42V
    • Minimum 2.5V for V(BIAS) ≥ 4.5V or VOUT ≥ 6V
  • Output Voltage 6V to 60V
    • 2% accuracy, internal feedback resistors
    • Bypass operation for VI > VOUT
    • Dynamic output voltage tracking
      • Digital PWM tracking (DTRK)
      • Analog tracking (ATRK)
    • Overvoltage protection (64V, 50V, 35V, 28.5V)
  • Low shutdown IQ of 2µA
  • Low operating IQ of 1.4mA
  • Stacking with interleaved multiphase operation
    • Up to 4-phases without external clock
  • Switching frequency from 100kHz to 2.2MHz
    • Synchronization to external clock (SYNCIN)
    • Dynamically selectable switching modes (FPWM, diode emulation)
    • Spread spectrum (DRSS)
  • Selectable dead time (14ns to 200ns)
  • Current sense resistor or DCR sensing
  • Average inductor current monitor
  • Average input current limit
    • Programmable current limit
    • Selectable delay time
  • Power-good indicator
  • Programmable VI undervoltage lockout (UVLO)
  • Lead-less VQFN-32 package with wettable flanks

The LM5125A-Q1 is a stackable, dual-phase, synchronous boost controller. The device provides a regulated output voltage for lower or equal input voltage also supporting VI to VOUT bypass mode to save power. Stack two devices with or without external clock.

Dynamically program VOUT using the analog or digital ATRK/DTRK function. VI is supported down to 2.5V after start-up as the internal VCC supply is automatically switched from VBIAS to VOUT for VBIAS < 4.5V. The fixed switching frequency is set between 100kHz and 2.2MHz through a resistor on the RT pin or the SYNCIN clock. The switching modes FPWM or diode emulation can be changed during operation.

The implemented protections peak current limit, average input current limit, average inductor current monitor, over and undervoltage protection, and the thermal shutdown protect the device and the application.

The LM5125A-Q1 is a stackable, dual-phase, synchronous boost controller. The device provides a regulated output voltage for lower or equal input voltage also supporting VI to VOUT bypass mode to save power. Stack two devices with or without external clock.

Dynamically program VOUT using the analog or digital ATRK/DTRK function. VI is supported down to 2.5V after start-up as the internal VCC supply is automatically switched from VBIAS to VOUT for VBIAS < 4.5V. The fixed switching frequency is set between 100kHz and 2.2MHz through a resistor on the RT pin or the SYNCIN clock. The switching modes FPWM or diode emulation can be changed during operation.

The implemented protections peak current limit, average input current limit, average inductor current monitor, over and undervoltage protection, and the thermal shutdown protect the device and the application.
filter 尋找其它 DC/DC 控制器
下載 觀看有字幕稿的影片 影片

您可能會感興趣的類似產品

open-in-new 比較替代產品
功能與所比較的裝置相似
最新 LM5171-Q1 現行 車用 80V 雙通道雙向降壓/升壓控制器 LM5171-Q1 can support higher output power up to 2kW power due to larger 5A gate drivers

技術文件

star =TI 所選的此產品重要文件
找不到結果。請清除您的搜尋條件，然後再試一次。
檢視所有 5
重要文件 類型 標題 格式選項 日期
* Data sheet LM5125 A -Q1, Wide-VIN, Dual-Phase, Automotive, Boost Controller With VOUT Tracking datasheet (Rev. A) PDF | HTML 2026年 1月 28日
Application note Multiphase Operation of LM5125A-Q1 PDF | HTML 2026年 7月 9日
Application note Optimizing the High Side Switch Gate Ringing PDF | HTML 2026年 4月 16日
Application note Asynchronous Operation of LM5125x Boost Controller PDF | HTML 2025年 12月 2日
Functional safety information LM5125-Q1, LM5125A-Q1, and LM51251A-Q1 Functional Safety FIT Rate, FMD and Pin FMA (Rev. A) PDF | HTML 2025年 9月 9日

設計與開發

如需其他條款或必要資源，請按一下下方的任何標題以檢視詳細頁面 (如有)。

開發板

LM5125AEVM-BST — LM5125AEVM-BST 評估模組

LM5125AEVM-BST 評估模組展示了 LM5125A-Q1 寬輸入電壓同步雙相升壓控制器的功能和性能。此 EVM 旨在簡化配置，讓使用者能夠評估模組在不同條件下的性能。EVM 預設提供 24V/240W 輸出。可透過 ATRK/DTRK 接腳動態調整輸出電壓。
使用指南: PDF | HTML
TI.com 無法提供
計算工具

LM5125-CALC — LM5125(A) quick start calculator

LM5125(A) quick start calculator helps on design of the power stage, component selection and loop compensation.
支援產品和硬體

支援產品和硬體
下載
參考設計

TIDA-020088 — 八通道 1kVA H 類音訊放大器參考設計

此參考設計展示 1kVA H 類音訊與追蹤電源供應音訊子系統。TAS6684-Q1 音訊放大器可追蹤數位音訊輸入的包絡線，並調整 LM5125A-Q1 升壓輸出電壓以符合電源效率需求，無需使用外部微控制器。此設計可提升效率、熱性能，且總佔用面積更小。此外，此參考設計也允許 H 類實作隨插即用，對汽車音訊架構的其他部分只有最少的軟體更動。
Design guide: PDF
參考設計

PMP31263 — 適合 H 類音訊應用的雙相位升壓轉換器參考設計

此參考設計採用適用於 H 類音訊應用的雙相位車用升壓轉換器，可提供類比或數位輸出電壓追蹤。在 11V 輸入電壓下可達到 800W 以上的峰值輸出功率。

此測試報告以使用外部電阻器進行配置的 LM5125-Q1 為基礎。此設計也可使用提供 I²C 以進行診斷和控制的接腳相容 LM51251-Q1 變體。

Test report: PDF
參考設計

PMP31306 — 適合 H 類音訊應用的 GaN 式雙相位升壓轉換器參考設計

此設計為雙相汽車升壓轉換器，採用 LMG2100R026 氮化鎵 (GaN) 半橋並提供類比或數位輸出電壓追蹤，適用於 H 類音訊應用。11V 輸入電壓下的輸出功率為 1000W（12V 時峰值為 1250W）。轉換器面積測量為 47mm × 48mm，不包括反向極性保護和大型輸入電容。此設計是以 LM5125-Q1 為基礎。此設計也可使用提供額外 I²C 以進行診斷和控制的接腳相容 LM51251-Q1 變體。
Test report: PDF
封裝 針腳 CAD 符號、佔位空間與 3D 模型
VQFN (RHB) 32 Ultra Librarian
適用 TI 的評估品項標準條款與條件。

訂購與品質

內含資訊：
  • RoHS
  • REACH
  • 產品標記
  • 鉛塗層/球物料
  • MSL 等級/回焊峰值
  • MTBF/FIT 估算值
  • 材料內容
  • 認證摘要
  • 進行中的可靠性監測
內含資訊：
  • 晶圓廠位置
  • 組裝地點

建議產品可能具有與此 TI 產品相關的參數、評估模組或參考設計。

支援與培訓

內含 TI 工程師技術支援的 TI E2E™ 論壇

以英文檢視所有論壇主題

內容係由 TI 和社群貢獻者依「現狀」提供，且不構成 TI 規範。檢視使用條款。

若有關於品質、封裝或訂購 TI 產品的問題，請參閱 TI 支援。​​​​​​​​​​​​​​

影片