首頁 電源管理 AC/DC 和 DC/DC 控制器 (外部 FET)
首頁
電源管理
AC/DC 和 DC/DC 控制器 (外部 FET)
最新

LM517701

現行

78V wide-VIN bidirectional 4-switch buck-boost controller

立即訂購
產品規格表

LM517701

現行
產品規格表 立即訂購

產品詳細資料

Rating Catalog Topology Buck-Boost Vin (max) (V) 78 Vin (min) (V) 2.8 Vout (max) (V) 78 Vout (min) (V) 3.3 Features Adjustable current limit, Dynamic voltage scaling, Enable, Frequency synchronization, Light-load efficiency, Load Disconnect, Power good, Spread Spectrum, Synchronous rectification, Tracking, UVLO adjustable Operating temperature range (°C) -40 to 125 Iq (typ) (µA) 60 Duty cycle (max) (%) 100 EMI features Frequency Dithering, Spread Spectrum
Rating Catalog Topology Buck-Boost Vin (max) (V) 78 Vin (min) (V) 2.8 Vout (max) (V) 78 Vout (min) (V) 3.3 Features Adjustable current limit, Dynamic voltage scaling, Enable, Frequency synchronization, Light-load efficiency, Load Disconnect, Power good, Spread Spectrum, Synchronous rectification, Tracking, UVLO adjustable Operating temperature range (°C) -40 to 125 Iq (typ) (µA) 60 Duty cycle (max) (%) 100 EMI features Frequency Dithering, Spread Spectrum
HTSSOP (DCP) 38 62.08 mm² 9.7 x 6.4
  • Wide input range from 3.5V to 78V (85V absolute maximum)
    • Minimum 2.8V when V(BIAS) > 3.5V
  • Output voltage from 3.3V to 78V
  • Low shutdown IQ of 3µA
  • Low operating IQ of 60µA
  • 3% reverse current limit accuracy for precise charging currents
  • Average input and output current monitor or limiter
  • Dynamic output voltage tracking for PWM or analog input signals
  • Power save mode (PSM) selectable for high light load efficiency
  • Two integrated high-voltage supply LDOs with automatic selection
  • Fixed frequency across all operating modes (boost, buck-boost, buck)
    • Forced PWM mode selectable
    • Switching up to 1.8MHz for small solution and component size
    • External clock synchronization
  • Spread spectrum operation selectable
  • Adjustable undervoltage protection
  • Hiccup overcurrent and short protection
  • Wide input range from 3.5V to 78V (85V absolute maximum)
    • Minimum 2.8V when V(BIAS) > 3.5V
  • Output voltage from 3.3V to 78V
  • Low shutdown IQ of 3µA
  • Low operating IQ of 60µA
  • 3% reverse current limit accuracy for precise charging currents
  • Average input and output current monitor or limiter
  • Dynamic output voltage tracking for PWM or analog input signals
  • Power save mode (PSM) selectable for high light load efficiency
  • Two integrated high-voltage supply LDOs with automatic selection
  • Fixed frequency across all operating modes (boost, buck-boost, buck)
    • Forced PWM mode selectable
    • Switching up to 1.8MHz for small solution and component size
    • External clock synchronization
  • Spread spectrum operation selectable
  • Adjustable undervoltage protection
  • Hiccup overcurrent and short protection

The LM51770x is a four switch buck-boost controller. The device provides a regulated output voltage if the input voltage is higher, equal, or lower than the adjusted output voltage. In power save mode, the device supports high efficiency with low output loads due to its low quiescence currents. In power save mode, the device supports high efficiency close to 99% efficiency over the full range of the output current. The LM51770x runs at a fixed switching frequency, which is set through the RT or SYNC pin. The switching frequency remains the same during buck, boost, and buck-boost operation. The integrated and optional average current monitor helps monitor and limit input and output current of the LM51770x. This feature also supports charging backup power elements, like batteries or capacitors, with constant current (CC) and constant voltage (CV).

The LM51770x is a four switch buck-boost controller. The device provides a regulated output voltage if the input voltage is higher, equal, or lower than the adjusted output voltage. In power save mode, the device supports high efficiency with low output loads due to its low quiescence currents. In power save mode, the device supports high efficiency close to 99% efficiency over the full range of the output current. The LM51770x runs at a fixed switching frequency, which is set through the RT or SYNC pin. The switching frequency remains the same during buck, boost, and buck-boost operation. The integrated and optional average current monitor helps monitor and limit input and output current of the LM51770x. This feature also supports charging backup power elements, like batteries or capacitors, with constant current (CC) and constant voltage (CV).
filter 尋找其它 AC/DC 和 DC/DC 控制器 (外部 FET)
下載 觀看有字幕稿的影片 影片

技術文件

star =TI 所選的此產品重要文件
找不到結果。請清除您的搜尋條件，然後再試一次。
檢視所有 1
類型 標題 日期
* Data sheet LM51770x 78V Wide VIN Bidirectional 4-Switch Buck-Boost Controller datasheet (Rev. A) PDF | HTML 2025年 8月 20日

設計與開發

如需其他條款或必要資源，請按一下下方的任何標題以檢視詳細頁面 (如有)。

開發板

LM5177EVM-HP — 具四開關降壓升壓控制器的 LM5177 評估模組

LM5177EVM-HP 展示使用 LM5177 wide-vin 降壓升壓控制器的靈活高功率降壓升壓設計。評估模組設定為在 4.2 V 至 36 V 輸入電壓範圍內運作，並提供最高 9.4 A 負載電流的穩壓 16-V 輸出。
使用指南: PDF | HTML
TI.com 無法提供
計算工具

LM51770-QUICKSTART-CALC — LM51770 BuckBoost Quickstart Calculator Tool

LM51770 BuckBoost Quickstart Calculator Tool. This standalone tool facilitates and assists the power supply engineer with the design of a DC/DC buck-boost converter based on the LM51770.
支援產品和硬體

支援產品和硬體

產品
AC/DC 和 DC/DC 控制器 (外部 FET)
  • LM51770 — 78V 大範圍 VIN 雙向 4 開關降壓升壓控制器
  • LM51770-Q1 — 78V 大範圍 VIN 雙向 4 開關降壓升壓控制器
  • LM517701 — 78V wide-VIN bidirectional 4-switch buck-boost controller
硬體開發
開發板
  • LM51770EVM-HV — LM51770 buck-boost controller evaluation module
下載
封裝 針腳 CAD 符號、佔位空間與 3D 模型
HTSSOP (DCP) 38 Ultra Librarian
適用 TI 的評估品項標準條款與條件。

訂購與品質

內含資訊：
  • RoHS
  • REACH
  • 產品標記
  • 鉛塗層/球物料
  • MSL 等級/回焊峰值
  • MTBF/FIT 估算值
  • 材料內容
  • 認證摘要
  • 進行中持續性的可靠性監測
內含資訊：
  • 晶圓廠位置
  • 組裝地點

建議產品可能具有與此 TI 產品相關的參數、評估模組或參考設計。

支援與培訓

內含 TI 工程師技術支援的 TI E2E™ 論壇

以英文檢視所有論壇主題

內容係由 TI 和社群貢獻者依「現狀」提供，且不構成 TI 規範。檢視使用條款。

若有關於品質、封裝或訂購 TI 產品的問題，請參閱 TI 支援。​​​​​​​​​​​​​​

影片