TPS62080
- DCS-Control™ Architecture for Fast Transient Regulation
- Snooze Mode for 6.5-µA Ultra Low Quiescent Current
- 2.3-V to 6-V Input Voltage Range
- 100% Duty Cycle for Lowest Dropout
- Power Save Mode for Light-Load Efficiency
- Output Discharge Function
- Short-Circuit Protection
- Power-Good Output
- Thermal Shutdown
- Available in 2-mm × 2-mm 8-Pin WSON Package
The TPS6208x devices are a family of high frequency synchronous step down converters. With an input voltage range of 2.3 V to 6 V, common battery technologies are supported. Alternatively, the device can be used for low voltage system power rails.
The TPS6208x focuses on high efficiency step-down conversion over a wide output current range. At medium to heavy loads, the converter operates in PWM mode and automatically enters Power Save Mode operation at light load currents to maintain high efficiency over the entire load current range. To maintain high efficiency at very low load or no load currents, a Snooze Mode with an ultra-low quiescent current is implemented. This function, enabled by the MODE pin, increases the run-time of battery driven applications and keeps the standby current at its lowest level to meet green energy standards targeting a low stand-by current.
To address the requirements of system power rails, the internal loop compensation allows a large selection of external output capacitor values in excess of 100 µF. With its DCS-Control™ architecture, excellent load transient performance and output voltage regulation accuracy is achieved. The device is available in 2-mm × 2-mm WSON package with Thermal PAD.
技術文件
設計與開發
如需其他條款或必要資源,請按一下下方的任何標題以檢視詳細頁面 (如有)。
TPS62080EVM-641 — 1.2-A、高效率降壓轉換器評估模組
The TPS62080EVM-641 is an evaluation module (EVM) for TPS62080. 1.2-A, High-Efficiency, Step-Down Converter. The TPS6208x focuses on high-efficiency, step-down conversion over a wide output current range. At medium-to-heavy loads, the converter operates in PWM mode and automatically enters PFM or (...)
SLVC780 — Design Tool for Output Voltage Adjustment Using a DAC
TIDA-00499 — 使用差動放大器和 HS ADC 的暫態及數位故障記錄器 AFE 參考設計
數位故障記錄器 (DFR) 可在 60/50 Hz 下偵測 17/20 μs 的暫態,而暫態記錄器則可擷取能在毫秒內達到峰值與衰退的干擾。此參考設計展示以 1 MHz 擷取 DFR 暫態輸入,針對暫態構造器則以 25 MHz 擷取暫態輸入。正負暫態 (<=100-kV 峰值) 皆可視應用需求以不同解析度擷取 (12 位元至 14 位元解析度),並使用驅動高速轉換器的差動放大器在 2 準確度內執行擷取。
TIDA-010011 — 用於保護繼電器處理器模組的高效電源供應架構參考設計
TIDM-MINI-DC — 適用於較小型 AMI 網路、可降低基礎設施成本的資料集中器參考設計
| 封裝 | 針腳 | CAD 符號、佔位空間與 3D 模型 |
|---|---|---|
| WSON (DSG) | 8 | Ultra Librarian |
訂購與品質
建議產品可能具有與此 TI 產品相關的參數、評估模組或參考設計。