首頁 電源管理 DC/DC 切換穩壓器 DC/DC 轉換器
首頁
電源管理
DC/DC 切換穩壓器
DC/DC 轉換器

TPS63060-EP

現行

具 2-A 開關電流的高輸入電壓降壓升壓轉換器

立即訂購
產品規格表

TPS63060-EP

現行
產品規格表 立即訂購

產品詳細資料

Rating HiRel Enhanced Product Topology Buck-Boost Vin (max) (V) 12 Vin (min) (V) 2.5 Vout (max) (V) 8 Vout (min) (V) 2.5 Switch current limit (typ) (A) 2.25 Features Enable, Frequency synchronization, Light-load efficiency, Load Disconnect, Power good, Synchronous rectification, UVLO fixed Operating temperature range (°C) -55 to 125 Iq (typ) (A) 0.00003 Duty cycle (max) (%) 100
Rating HiRel Enhanced Product Topology Buck-Boost Vin (max) (V) 12 Vin (min) (V) 2.5 Vout (max) (V) 8 Vout (min) (V) 2.5 Switch current limit (typ) (A) 2.25 Features Enable, Frequency synchronization, Light-load efficiency, Load Disconnect, Power good, Synchronous rectification, UVLO fixed Operating temperature range (°C) -55 to 125 Iq (typ) (A) 0.00003 Duty cycle (max) (%) 100
WSON (DSC) 10 9 mm² (3 mm × 3 mm)
  • Up to 93% Efficiency
  • 2A/1A Output Current at 5V in Buck Mode
  • 1.3A Output Current at 5V in Boost Mode (VIN>4V)
  • Automatic Transition Between Step Down and Boost Mode
  • Typical Device Quiescent Current less than 30µA
  • Input Voltage Range: 2.5V to 12V
  • Fixed and Adjustable Output Voltage Options from 2.5V to 8V
  • Power Save Mode for Improved Efficiency at Low Output Power
  • Forced Fixed Frequency Operation at 2.4MHz and Synchronization
    Possible
  • Power Good Output
  • Buck-Boost Overlap Control
  • Load Disconnect During Shutdown
  • Overtemperature Protection
  • Overvoltage Protection
  • Available in a 3-mm × 3-mm, SON-10 Package
  • Up to 93% Efficiency
  • 2A/1A Output Current at 5V in Buck Mode
  • 1.3A Output Current at 5V in Boost Mode (VIN>4V)
  • Automatic Transition Between Step Down and Boost Mode
  • Typical Device Quiescent Current less than 30µA
  • Input Voltage Range: 2.5V to 12V
  • Fixed and Adjustable Output Voltage Options from 2.5V to 8V
  • Power Save Mode for Improved Efficiency at Low Output Power
  • Forced Fixed Frequency Operation at 2.4MHz and Synchronization
    Possible
  • Power Good Output
  • Buck-Boost Overlap Control
  • Load Disconnect During Shutdown
  • Overtemperature Protection
  • Overvoltage Protection
  • Available in a 3-mm × 3-mm, SON-10 Package

The TPS63060 provides a power supply solution for products powered by either three-cell up to six-cell alkaline, NiCd or NiMH battery, or a one-cell or dual-cell Li-Ion or Li-polymer battery. Output currents can go as high as 2A while using a dual-cell Li-Ion or Li-Polymer Battery, and discharge it down to 5V or lower. The buck-boost converter is based on a fixed frequency, pulse-width-modulation (PWM) controller using synchronous rectification to obtain maximum efficiency. At low load currents, the converter enters Power Save mode to maintain high efficiency over a wide load current range. The Power Save mode can be disabled, forcing the converter to operate at a fixed switching frequency. The maximum average current in the switches is limited to a typical value of 2.25A. The output voltage is programmable using an external resistor divider, or is fixed internally on the chip. The converter can be disabled to minimize battery drain. During shutdown, the load is disconnected from the battery. The device is packaged in a 10-pin SON PowerPAD package measuring 3mm × 3mm (DSC).

The TPS63060 provides a power supply solution for products powered by either three-cell up to six-cell alkaline, NiCd or NiMH battery, or a one-cell or dual-cell Li-Ion or Li-polymer battery. Output currents can go as high as 2A while using a dual-cell Li-Ion or Li-Polymer Battery, and discharge it down to 5V or lower. The buck-boost converter is based on a fixed frequency, pulse-width-modulation (PWM) controller using synchronous rectification to obtain maximum efficiency. At low load currents, the converter enters Power Save mode to maintain high efficiency over a wide load current range. The Power Save mode can be disabled, forcing the converter to operate at a fixed switching frequency. The maximum average current in the switches is limited to a typical value of 2.25A. The output voltage is programmable using an external resistor divider, or is fixed internally on the chip. The converter can be disabled to minimize battery drain. During shutdown, the load is disconnected from the battery. The device is packaged in a 10-pin SON PowerPAD package measuring 3mm × 3mm (DSC).
filter 尋找其它 DC/DC 轉換器
下載 觀看有字幕稿的影片 影片

您可能會感興趣的類似產品

open-in-new 比較替代產品
功能相同，但針腳輸出與所比較的裝置不同。
TPS63060 現行 2.5V 至 12V 輸入電壓、93% 效率、2.25A 開關電流限制、降壓升壓轉換器 Commercial grade

技術文件

找不到結果。請清除您的搜尋條件，然後再試一次。
檢視所有 4
重要文件 類型 標題 格式選項 下載最新的英文版本 日期
* 資料表 HIGH INPUT VOLTAGE BUCK-BOOST CONVERTER WITH 2-A SWITCH CURRENT datasheet 2013/12/26
* 輻射及可靠性報告 TPS63060MDSCTEP Reliability Report 2014/12/16
* VID TPS63060-EP VID V6214602 2016/6/21
應用說明 Understanding Undervoltage Lockout in Power Devices (Rev. A) 2018/9/19

設計與開發

如需其他條款或必要資源，請按一下下方的任何標題以檢視詳細頁面 (如有)。

計算工具

SLVC808 — Battery Lifetime Estimator

支援產品和硬體
封裝 針腳 CAD 符號、佔位空間與 3D 模型
WSON (DSC) 10 Ultra Librarian
適用 TI 的評估品項標準條款與條件。

訂購與品質

建議產品可能具有與此 TI 產品相關的參數、評估模組或參考設計。

支援與培訓

內含 TI 工程師技術支援的 TI E2E™ 論壇

以英文檢視所有論壇主題

內容係由 TI 和社群貢獻者依「現狀」提供，且不構成 TI 規範。檢視使用條款。

若有關於品質、封裝或訂購 TI 產品的問題，請參閱 TI 支援。​​​​​​​​​​​​​​

影片