SBAU407 april   2023 ADS8354

 

  1.   Abstract
  2.   Trademarks
  3. 1Overview
    1. 1.1 ADS8354EVM-PDK Features
    2. 1.2 ADS8354EVM Features
    3. 1.3 Related Documentation From Texas Instruments
  4. 2Analog Interface
    1. 2.1 Connectors for Analog Inputs
    2. 2.2 ADC Input Signal Driver
      1. 2.2.1 Input Signal Path
  5. 3Digital Interfaces
    1. 3.1 SPI for the ADC Digital I/O
  6. 4Power Supplies
    1. 4.1 ADC Input Driver Configuration
    2. 4.2 ADC Voltage Reference Configuration
  7. 5ADS8354EVM-PDK Initial Setup
    1. 5.1 Default Jumper Settings
    2. 5.2 EVM Graphical User Interface Software Installation
  8. 6ADS8354EVM-PDK Operation
    1. 6.1 EVM GUI Global Settings for ADC Control
    2. 6.2 Time Domain Display Tool
    3. 6.3 Spectral Analysis Tool
    4. 6.4 Histogram Analysis Tool
  9. 7Bill of Materials, Printed-Circuit Board Layout, and Schematics
    1. 7.1 Bill of Materials
    2. 7.2 PCB Layout
    3. 7.3 Schematics

6 ADS8354EVM-PDK Operation

The following instructions are a step-by-step guide for connecting the device to a computer and evaluating the performance of the device.

  1. Connect the device EVM to the PHI board. Figure 6-1 indicates where the screws are to be installed.
  2. Use the provided USB cable to connect the PHI to the computer.
    • LED D5 on the PHI lights up, indicating that the PHI is powered up.
    • LEDs D1 and D2 on the PHI start flashing, indicating that the PHI is booted up and communicating with the PC.
    GUID-20230223-SS0I-BBXT-VZ6W-LWXQSS0FKCQZ-low.svg Figure 6-1 EVM-PDK Hardware Setup and LED Indicators
  3. Launch the device EVM GUI software from the installed path, as Figure 6-2 shows, or by using the desktop shortcut created during installation.
    GUID-20230223-SS0I-BSGW-T7TH-WTLGZZXFDFDM-low.svg Figure 6-2 Launch the EVM GUI Software