TPS3513
- Overvoltage Protection and Lockout for 12 V,
5 V, and 3.3 V - Overcurrent Protection and Lockout for 12 V,
5 V, and 3.3 V - Undervoltage Protection and Lockout for 12 V,
and Undervoltage Detect for 5 V and 3.3 V - Fault-Protection Output With Open Drain Output Stage
- Open-Drain, Power Good Output Signal for Power-Good Input,
3.3 V and 5 V - 300-ms Power-Good Delay
- 75-ms Delay for 5-V and 3.3-V Power Supply
Short-Circuit Turnon Protection - 2.3 ms PSON Control to FPO Turnoff Delay
- 38 ms PSON Control Debounce
- Wide Supply Voltage Range From 4.5 V
to 15 V
The TPS3513 is designed to optimize PC switching power supply system with minimum external components. It provides undervoltage lockout (UVLO), protection circuits, power good indicator, and on/off control.
UVLO thresholds are 4.45 V (on) and 3.65 V (off). Overcurrent protection (OCP) and overvoltage protection (OVP) monitor 3.3 V, 5 V, and 12 V. When an OC or OV condition is detected, the power-good output (PGO) is asserted low and the fault protection output (FPO) is latched high. PSON from low-to-high resets the latch. The OCP function will be enabled 75 ms after PSON goes low, and a debounce of typically 38 ms. A built-in 2.3-ms delay with 38-ms debounce from PSON to FPO output is enabled at turnoff.
An external resistor is connected between the RI pin and the GND pin. This will introduce an accurate I(ref) for OCP function. The I(ref) range is from 12.5 µA to 62.5 µA. The formula for choosing RI resistor is V(RI)/I(ref). Three OCP comparators and the I(ref) section are supplied by VS12. The current draw from the VS12 pin is less than 1 mA.
The power good feature monitors PGI, 3.3 V and 5 V, and issues a power good signal when the output is ready.
The TPS3513 is characterized for operation from –40°C to 85°C.
기술 문서
유형 | 직함 | 날짜 | ||
---|---|---|---|---|
* | Data sheet | PC-Power Supply Supervisor datasheet (Rev. B) | 2010/09/08 | |
Application note | Optimizing Resistor Dividers at a Comparator (Rev. B) | PDF | HTML | 2021/04/30 | |
Selection guide | Voltage Supervisors (Reset ICs) Quick Reference Guide (Rev. H) | 2020/02/28 | ||
E-book | Voltage Supervisor and Reset ICs: Tips, Tricks and Basics | 2019/06/28 | ||
Selection guide | Power Management Guide 2018 (Rev. R) | 2018/06/25 |
설계 및 개발
추가 조건 또는 필수 리소스는 사용 가능한 경우 아래 제목을 클릭하여 세부 정보 페이지를 확인하세요.
PSPICE-FOR-TI — TI 설계 및 시뮬레이션 툴용 PSpice®
TI 설계 및 시뮬레이션 환경용 PSpice는 기본 제공 라이브러리를 이용해 복잡한 혼합 신호 설계를 시뮬레이션할 수 있습니다. 레이아웃 및 제작에 (...)
패키지 | 핀 | 다운로드 |
---|---|---|
PDIP (N) | 14 | 옵션 보기 |
SOIC (D) | 14 | 옵션 보기 |
주문 및 품질
- RoHS
- REACH
- 디바이스 마킹
- 납 마감/볼 재질
- MSL 등급/피크 리플로우
- MTBF/FIT 예측
- 물질 성분
- 인증 요약
- 지속적인 신뢰성 모니터링
- 팹 위치
- 조립 위치