DLPU130 December   2023

 

  1.   1
  2.   Description
  3.   Features
  4.   Applications
  5.   5
  6. 1Evaluation Module Overview
    1. 1.1 Introduction
    2. 1.2 Kit Contents
    3. 1.3 Specification
    4. 1.4 Device Information
  7. 2Hardware
    1. 2.1 Additional Image
    2. 2.2 Power Requirements
    3. 2.3 Connector/Header Information
    4. 2.4 Boot Mode Pin Mapping
    5. 2.5 Debug Information
  8. 3Software
    1. 3.1 Software Installation
  9. 4Hardware Design Files
    1. 4.1 Schematics
    2. 4.2 PCB Layouts
    3. 4.3 Bill of Materials (BOM)
  10. 5Additional Information
    1. 5.1 Trademarks

2.3 Connector/Header Information

Table 2-1 Installed Connectors/Headers
INSTALLED CONNECTORS/HEADERS DESCRIPTION
J1 Connector for 12 V external power supply interface.
J3 Header for the 1.2V supply. Install jumper on Pin 1 and Pin 2 to use on-board regulator for 1.2V.
J4 Header for the 1.8V supply. Install jumper on Pin 1 and Pin 2 to use on-board regulator for 1.8V.
J5 Header for the 3.3V supply. Install jumper on Pin 1 and Pin 2 to use on-board regulator for 3.3V.
J6 Header for the 5.0V supply. Install jumper on Pin 1 and Pin 2 to use on-board regulator for 5.0V.
J7 Connector for 12 V banana cable positive terminal.
J8 Connector for banana cable ground terminal.
J10 Header for Sitara MCU boot mode select. Refer to Section 2.4.
J11 Total Phase Cheetah USB to SPI adapter.
J12 JTAG Programming/Debug interface.
J14 CAN/LIN/I2C/UART daughtercard socket.
J15 Ethernet RMII daughtercard socket.
J16 LED connector.