SLAU813A September   2019  – October 2020 TPA6304-Q1

 

  1.   Trademarks
  2. 1Required Equipment and Accessories:
  3. 2Hardware Overview
    1. 2.1 TPA6304Q1 Evaluation Module Description
    2. 2.2 TPA6304-Q1 Evaluation Module Functions
  4. 3Software Overview
    1. 3.1 PurePath™ Console 3 (PPC3) Access and Description
    2. 3.2 PurePath™ Console 3 – TPA6304Q1EVM Home Window
    3. 3.3 PurePath™ Console 3 – TPA6304Q1EVM Register Map Window
    4. 3.4 PurePath™ Console 3 – TPA6304Q1EVM Monitor & Control Window
  5. 4TPA6304-Q1 Start Up
    1. 4.1 TPA6304Q1EVM Setup
    2. 4.2 TPA6304-Q1 Settings on Device Monitor & Control Window
      1. 4.2.1 Device State Control Section
      2. 4.2.2 Channel Control Section
      3. 4.2.3 Miscellaneous Control Section
      4. 4.2.4 Fault / Warning Signal Configuration Section
      5. 4.2.5 Faults / Warnings Section
      6. 4.2.6 AC Load Diagnostics Section
      7. 4.2.7 DC Load Diagnostics Section
      8. 4.2.8 Spread Spectrum Control Section
    3. 4.3 TPA6304-Q1 Settings on Register Map Window
    4. 4.4 I2C Monitor Window
  6. 5Board Layout, Schematic and Bill of Materials
    1. 5.1 Board Layout
    2. 5.2 Schematic
    3. 5.3 Bill of Materials
  7.   Revision History

3.2 PurePath™ Console 3 – TPA6304Q1EVM Home Window

There are three windows available with the TPA6304Q1EVM PPC3: Home Window, Register Map Window, and Device Monitor & Control Window. When the TPA6304Q1EVM PPC3 is launched, the Home Window displays (see Figure 3-6). If the EVM is powered on and the USB is connected to the PC, the Home Window displays the Connect box in the bottom left hand corner. If the EVM is not powered on or the USB is not connected, only TPA6304Q1EVM – Offline is displayed.

GUID-DE0DB778-C7FF-42BC-B99A-434242B3D5B8-low.png Figure 3-6 TPA6304Q1EVM Home Window