DLPU091A November   2019  – December 2025

 

  1.   1
  2.   Description
  3.   Get Started
  4.   Features
  5.   Applications
  6.   6
  7. 1Evaluation Module Overview
    1. 1.1 Introduction
    2. 1.2 Kit Contents
      1. 1.2.1 Driver Board
        1. 1.2.1.1 Driver Board - Illumination Driver
      2. 1.2.2 EVM Cables
    3. 1.3 Specifications
      1. 1.3.1 Electrical Specifications
      2. 1.3.2 Component Temperature Ratings
      3. 1.3.3 Input Video Specifications
      4. 1.3.4 SPI and I2C Timing
    4. 1.4 Device Information
  8. 2Hardware
    1. 2.1 Quick Start
      1. 2.1.1 Kit Assembly Instructions
      2. 2.1.2 Powering-Up EVM
    2. 2.2 Optical Engine Specification
  9. 3Software
    1. 3.1 Software Installation
    2. 3.2 Changing Product Option to HUD Mode
    3. 3.3 Connecting EVM to the DLPC230-Q1 Control Program
    4. 3.4 Steps to Reprogram the Onboard Flash Memory
  10. 4Hardware Design Files
    1. 4.1 Schematics
    2. 4.2 PCB Layouts
    3. 4.3 Bill of Materials (BOM)
  11. 5Compliance Information
    1. 5.1 REACH Compliance
  12. 6Additional Information
    1. 6.1 Trademarks
    2.     37
  13. 7Revision History

2.1.2 Powering-Up EVM

  1. Turn the HW/SW DIP (SW1) switch to the HW position to enable manual control of the PROJ_ON switch.
  2. Connect input power cable to a power supply that meets input power specifications defined in Table 1-5. The red wire is the V+ terminal and black wire is the V– terminal.
  3. Turn on the supply power. Once powered up, a controller PCB LED indicator (D7) illuminates green. In addition to this LED, the MCU powergood LED (D31) and heartbeat LED (D30) illuminates blue and green, respectively. The heatbeat LED blinks on and off.
  4. Turn the PROJ_ON switch (SW2) ON. The ON position is away from the board, and OFF is toward the board. The silkscreen indicates these positions. A controller PCB LED indicator (D6) illuminates green.