DLPU103B october   2020  – may 2023 DLP230NP

 

  1.   1
  2.   DLP LightCrafter Display 230NP EVM
  3.   Trademarks
  4. 1  DLP LightCrafter Display 230NP EVM Overview
  5. 2 Safety Instructions
  6. 3 Applicable Documents
  7. 4 What is in the DLP LightCrafter Display 230NP EVM?
  8. 5 Light Engine
  9. 6 Quick-Start Procedure
  10. 7 Connectors on Formatter Board
  11. 8 EVM Setup
  12. 9 Raspberry Pi Guide
    1. 9.1 Raspberry Pi General Configuration
    2. 9.2 Video Timing Configuration
    3. 9.3 Python Support Software
    4. 9.4 Operating Modes
    5. 9.5 Example Applications
      1. 9.5.1 Initialize Communication Between Raspberry Pi and EVM
      2. 9.5.2 Play Video Content from Raspberry Pi
      3. 9.5.3 Execute Sample Scripts Using Raspberry Pi
      4. 9.5.4 Rewrite Controller or FPGA Flash Device Using Raspberry Pi
  13. 10Troubleshooting
  14. 11Support Resources
  15. 12Revision History

7 Connectors on Formatter Board

Table 7-1 Installed Connectors on Formatter Board
Installed Connectors and HeadersDescription
JPWR1Connector for 5-V external power supply interface
J1Connector for optical engine flex cable.
J2Connector (40 pin) for Raspberry PI cable
J3Connector (41 pin) for FPD Link interface (not installed by default)
J4Connector for 5-V cooling fan
J500Connector for DMD interface flex cable
J501Connector for Green LED cable
J502Connector for Red LED cable
J503Connector for Blue LED cable