PBC Control Enable
checkbox - enable software control of DMD parameters through I2C.
Note: When not checked the software DMD Control flags
are ignored and are controlled by DLPC910 input pins (default = not checked
- external pin control)
Flip top and
bottom checkbox - swaps the top of the DMD and the
bottom (default = not flipped):
Zero
row - go to beginning row becomes go to end
Increment row mode becomes "decrement"
row mode
Note: Set row addressing is not affected by
this flag.
Invert data
checkbox - complements the input data [1 → 0 and 0 → 1] (default = not
inverted)
Load 4 mode
checkbox - loads 4 DMD rows for each row input (default = normal load
mode)
Enable
rst2blkz checkbox - sets the DMD flag to receive quad block
reset requests (default = not enabled)